Bosch EX36 Installation Manual download pdf (Page 10)

8 en | EX36-IP

MAN36IPB Rev.0 | 2008.10 Quick Install Bosch Security Systems

“ON” (850nm LEDs will have a slight red glow). Adjust the

LED power if they are too bright or too dim. For IR power

adjustment, rotate VR1. Clockwise is high and counter-

clockwise is low.

2.4) Photocell adjustment

The photocell is factory set optimum level. In some condi-

tions such as with bright foreground objects the camera may

switch too early or too late. For photocell “On/Off” light-level

adjustment, rotate IR Adjustment Pot. Clockwise is off and

counter-clockwise is on.

2.5) Ethernet Connection.

Remove the two screws securing the Camera / LED

module from the camera housing. See the figure below.

Re-assemble the IP board into the chassis.

3.) Secure all cabling.

Camera Setup:

To determine if the camera is receiving a picture:

1.) Make sure the supplied software is installed in your PC/laptop

computer (For Camera Configuration and Software Viewing

Setup, refer to full version Installation Manual available on the

enclosed CD-ROM -Section 4).

2.) Connect the camera to the PC/laptop and power up the camera.

Follow the prompts. See section 2 of full version Installation

Manual available on the enclosed CD-ROM for more detail.

Ethernet

connector

1 2 ... 5 6 7 8 9 10 11 12 13 14

No comments

Bosch EX36 Installation Manual Page 10