Bosch EX36 Installation Manual download pdf (Page 8)

6 en | EX36-IP

MAN36IPB Rev.0 | 2008.10 Quick Install Bosch Security Systems

This view shows the interior layout of the EX36IP Camera assembly

after the faceplate has been removed.

2.3 Camera: Mounting and setup:

Select a suitable location that protects the camera from accidental

damage, tampering and environmental conditions exceeding the

specifications of the camera to be mounted.

These mounting guidelines should be followed:

1.) Locate the bracket such that it cannot be easily interfered with,

either intentionally or accidentally.

2.) Select a smooth, flat mounting surface to ensure proper sealing.

The surface must also be capable of supporting the combined

weight of the camera and mounting hardware under all expected

conditions of vibration and temperature. Camera performs best

mounted approximately 3m off the ground.

2.1) Camera housing mounting

Installations on drywall must use #8 screws and #8 drywall

nylon plugs or a superior connection. The camera’s mounting

holes are located on the left and right side of the housing.

Refer to figure below. Depending on the type of mounting

surface (brick, wood, etc.), it may be necessary to pre-drill

these holes for the mounting screws. It is recommended that

these holes be marked using the housing as a drill template

and then drilled separately. This way no burrs or debris will

fall into the housing. Ensure the power and video cables are

not crimped or stressed after the camera has been mounted.

CAUTION! Ensure the selected location is protected from falling

objects, accidental contact with moving objects and unintentional

interference from personnel. Follow all applicable building codes.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

Bosch EX36 Installation Manual Page 8