Bosch DIE 165 R User Manual download pdf (Page 9)

9

If you encounter a problem

If an

#

appears in the display:

❑ See "Filters and maintenance" Section.

If is not possible to operate the extractor

hood:

❑ Disconnect the extractor hood from the

mains electricity supply by pulling out the

plug or switching it off at the main fuse

box.

Wait for approx. 1 minute and then

switch it on again.

If you have any questions or if a fault

occurs, please call Customer Service.

(See list of Customer Service

representatives).

When you call, please quote the following:

E-Nr. FD

Enter the relevant numbers into the box

above. The E-Nr. (product no.) and FD

(production date) are shown on the

nameplate which can be seen inside the

extractor hood after the ﬁlter frame has

been detached.

IMPORTANT:

The manufacturer of the extractor hoods

accepts no liability for complaints which

can be attributed to the design and lay-

out of the pipework.

4. Re-insert the bulb ring.

5. Plug the appliance into the mains or

switch it on at the fuse box.

NOTE:

If the light does not function, check that the

bulbs have been inserted correctly.

Replacing the light bulbs

3. Replace the halogen light bulb

(conventional halogen bulb, 12 Volt,

max. 20 Watt, G4 cap).

NOTE: Refer for plug-in lampholder.

Take hold of the bulb with a clean cloth.

1. Switch off the extractor hood and pull

out the mains plug or switch off the

electricity supply at the fuse box.

 CAUTION:

When switched on, the halogen bulbs

become very hot. Even for some time after

the bulbs have been switched off there is

still a risk of burns.

2. Remove the bulb ring with a screwdriver

or similar tool.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 47 48

Comments to this Manuals

No comments