Bosch DiBos Micro Installation Guide Page 135

  • Download
  • Add to my manuals
  • Print
  • Page
    / 158
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 134
DiBos/DiBos Micro Connections | en 135
Bosch Sicherheitssysteme GmbH Installation Guide F.01U.033.308 | V7 | 2009.09
MINITER RS 485 contact assignment
Configuring MINITER RS 485 foyer card readers
Configuration is carried out with the MINITER RS 485 software. This can be installed on a
service laptop or on the video system. Proceed as follows to configure the card readers:
1. Start the configuration software and select RS485 operation.
2. Select the COM port to which the foyer card readers are connected via the Interface
menu item. Even if several MINITER RS 485 foyer card readers are to be programmed for
the first time, only one foyer card reader should be connected during programming. This
is because the foyer card reader will assign all the card readers with the same bus
address by default.
3. Select the MINITER > Miniter auslesen/identifizieren (Read/Identify Miniter) menu and
click Identifikation aller Adressen (Identification of all addresses). Adresse: 48
(Address: 48) and Protokoll: Bosch (Protocol: Bosch) is displayed.
4. Select foyer card reader number 48 and confirm your selection with OK.
5. Click Miniter auslesen (Read Miniter) and enter Passwort: 991357 (Password: 991357).
Confirm with OK.
6. The foyer card reader addresses must be assigned as follows.
Foyer card reader no. 1 = address 48
Foyer card reader no. 2 = address 49
Foyer card reader no. 3 = address 50
Foyer card reader no. 4 = address 51
The other parameters must be set as follows for operation:
Door opening time: optional
Door opener with buzzer: optional
Door opener interval tone: optional
Monitoring module: no
Password: 991357
Signal chip card: no
Send start character: no
Data on display: no
Evaluate track 2: yes
Evaluate track 3 or 1: yes
Open door on fault: no
Protocol: Bosch
Block list: optional
Data length track 2: 18 (for credit cards)
Data length track 3/1: 26 (for EC cards)
1Tamper switch
2 0 V DC input, GND (PIN 1)
3 Door opener output ground (PIN 2)
4 Standby contact/working contact door opener
output (PIN 3)
5 Signal RS 485- (PIN 4)
6 Signal RS 485+ (PIN 5)
7 + 12 V DC input (PIN 6)
8Fuse
1
5
2
6
3
7
4
8
Page view 134
1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 157 158

Comments to this Manuals

No comments