Bosch DiBos Micro Installation Guide Page 140

  • Download
  • Add to my manuals
  • Print
  • Page
    / 158
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 139
140 en | Connections DiBos/DiBos Micro
F.01U.033.308 | V7 | 2009.09 Installation Guide Bosch Sicherheitssysteme GmbH
10. Make the settings for the network protocol as follows: On the Networking Software
wizard page, select the Internet protocol (TCP/IP) entry from the list box and make sure
that there is a checkmark next to this entry.
Click Properties and make sure that in the Incoming TCP/IP properties dialog box,
the following settings are made: Allow callers to access my local area network
must not be selected. Specify TCP/IP addresses must be selected and the address
range from 169.254.x.1 to 169.254.x.254 must be entered. Number x must be a
unique system number in the customer's RAS network and may be assigned from 2
to 254.
Example: A customer owns 10 DiBos systems and 1 alarm receiver system. In this
case, number x varies from 2 to 12. The same number must not be used for two
different systems.
The option Allow calling computer to specify its own IP address must be selected.
Confirm with OK.
–Click the Next button on the wizard page.
11. On the Completing the Wizard wizard page, click Finish.
12. Make the necessary settings in the DiBos configuration.
Required configuration settings on the computer on which dialing in is to take place.
1. Select the Remote stations menu.
2. Activate the Accept incoming calls check box to allow dialing in via modem/ISDN.
Note:
When the check box is activated, you are requested to enter a password. Enter the
password to dial in to the computer.
3. Confirm the entries with OK.
Required configuration settings on the computer from which dialing in is to take place.
1. Select the Remote stations menu.
2. Click New and enter a name.
3. Activate the Modem/ISDN check box.
4. Under Number, enter the telephone number.
5. Leave the User field unchanged.
6. Click Enter password.
7. Enter the password for the computer on which dialing in is to take place.
8. Confirm the entries with OK.
Page view 139
1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 157 158

Comments to this Manuals

No comments