Bosch DiBos Micro Installation Guide download pdf (Page 39)

DiBos/DiBos Micro Quick Configuration | en 39

Bosch Sicherheitssysteme GmbH Installation Guide F.01U.033.308 | V7 | 2009.09

3 Pre-alarm time [sec.]: Enter the pre-alarm time for alarm and motion detection.

Values between 0 and 1800 seconds are allowed - with a

limit of 3600 images.

Note:

The recording rate during the pre- and post-alarm time is at

least 1 image per second. If the continuous recording rate is

higher than 1 image per second, this value is taken.

4 Post-alarm time [secs.]: Enter the post-alarm time. Values from 0 to 999 seconds are

allowed.

5 Finish Click the button to exit the basic configuration.

The video system is then started.

Log on with your user name and password. Make further

configuration entries if necessary.

Note:

When you click "Finish", the wizard automatically creates a

job for each camera. In this way, the camera number and job

number are the same, e.g. camera 01 - job 01, camera 02 -

job 02 etc. (up to a maximum of camera 30 - job 30). When

the wizard is run again, all the previous settings with the

designation job 01, job 02 ... job 30 will be overwritten.

If you do not want this to happen: Edit the designation of

the jobs in the configuration and do not name the newly

configured jobs as Job 01, Job 02 etc.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 157 158

No comments

Bosch DiBos Micro Installation Guide Page 39