Bosch DiBos Micro Installation Guide download pdf (Page 48)

48 en | Default Configuration DiBos/DiBos Micro

F.01U.033.308 | V7 | 2009.09 Installation Guide Bosch Sicherheitssysteme GmbH

Entering control commands via the command line

Here, you can specify various commands for dome cameras, pan/tilt cameras or matrix

switches via a command line. These commands can be called up manually or automatically.

The choice of commands available can be found in the operating manual of the respective

camera or matrix switch. The user can quickly select these commands in the live image,

assuming that these have been enabled for his level of authorization.

Camera control

The focus and iris can be set for each camera

Saving entries

5 Camera command line

First line:

The list contains preset control commands that you can

select.

Middle line (command line):

The command that you selected in the first line is displayed.

Alternatively, you can use this line to create a new command

if you do not find a suitable command in the drop-down list

for the first line.

Bottom line:

Assign the command a free number.

Save... Click the button to save. A dialog box opens. Enter a

meaningful name and confirm the entry. A message confirms

that this has been saved.

Note:

The command is available on the user interface.

Transmit Click the button to check the command.

Delete The saved command will be deleted.

6 Bilinx status: The status is displayed.

Iris and focus... Click the button. A dialog box opens to allow you to set the

iris and focus.

7 OK The entries are saved.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 157 158

No comments

Bosch DiBos Micro Installation Guide Page 48