Bosch DHG1003UC Installation Manual download pdf

WARNING - TO REDUCE THE

RISK OF FIRE, ELECTRIC SHOCK,

OR INJURY TO PERSONS, OB-

SERVE THE FOLLOWING:

A. Installation work and electrical wir-

ing must be done by qualified

person(s) in accordance with all ap-

plicable codes & standards, including

fire-rated construction.

B. Sufficient air is needed for proper

combustion and exhausting of gases

through the flue (chimney) of fuel

burning equipment to prevent back

drafting. Follow the heating equip-

ment manufacturers guideline and

safety standards such as those pub-

lished by the National Fire Protection

Association (NFPA), and the Ameri-

can Society for Heating, Refrigera-

tion and Air Conditioning Engineers

(ASHRAE), and the local code au-

thorities.

C. When cutting or drilling into wall or

ceiling, do not damage electrical wir-

ing and other hidden utilities.

D. To properly exhaust air, be sure to

duct air out side. Do not vent exhaust

air into spaces within walls, ceilings,

attics, crawl spaces, or garages.

WARNING: To reduce the risk of

fire, use only metal ductwork.

CAUTION - For General Ventilating

Use Only. Do Not Use To Exhaust

Hazardous Or Explosive Materials And

Vapors.

INSTALLATION:

1. Remove and discard shipping bracket (attached to motor

mounts and inlet collar). Check to see if blower wheel turns

freely. Do not replace top until installation is complete.

2. Provide a square cutout through the roof (or wall) as shown

by the dashed lines, or cut a round hole to fit duct with a

separate hole for electrical conduit as shown by solid lines

in Fig. 1.

3. Install the remote ventilator with the discharge pointing

down slope as shown in Figures 3 and 4. Follow standard

roofing procedures. Install the ventilator so the discharge

edge is on top of the shingles and the rear edge is

underneath the shingles.

PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING.

IMPORTANT: Save these instructions for the Local Electrical Inspector’s use.

INSTALLER: Please leave these Installation Instructions with this unit for the owner.

OWNER: Please retain these instructions for future reference.

Recommended for use only over conventional domestic gas and electric ranges, and

use with an approved Bosch Hood.

SAFETY WARNING: Before servic-

ing or cleaning unit, switch power off

at the service panel and lock service

disconnecting means to prevent

power from being switched on acci-

dentally. When the service discon-

necting means cannot be locked, at-

tach a tag to the service panel to

indicate power has been switched off

for maintenance.

NOTE: The unit must be sealed between the roof (or wall)

and the underside of the flange with roofing mastic to

prevent leaks. For installation on a flat roof, or roofs with

a pitch less than 1-1/2" in 12", install ventilator on the curb

as shown in Fig. 2. Position the curb on flat roofs so that

the discharge (low) end points away from prevailing wind.

4. Connect ventilator to the exhaust system with 8 inch diam.

duct for DHG6003UC and 10" diam. duct for DHG1003UC

and use adjustable elbow to adjust to roof angle. Tape all

joints to prevent air leaks.

5. Connect ducting in the inlet to the ventilator with duct tape.

6. Clearance to combustible material is 0".

For wiring to all approved Bosch products, see Installation

Instructions provided with that product.

INSTALLATION INSTRUCTIONS

ROOF OR WALL VENTILATOR

MODEL DHG6003UC & DHG1003UC

Dimension

Model A B C

DHG6003UC 5-11/16" 6-1/8" 9"

DHG1003UC 7-1/4" 6-15/16" 11"

Fig. 1 TOP VIEW Down Slope of Roof or Wall

(Over)

ONCE INSTALLATION AND WIRING ARE COMPLETE:

1. Turn ventilator on High for 5 minutes to ensure proper

installation.

2. Step to Medium & Low ensuring each speed setting.

3. Turn ventilator off.

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - ROOF OR WALL VENTILATOR

WARNING - TO REDUCE THERISK OF FIRE, ELECTRIC SHOCK,OR INJURY TO PERSONS, OB-SERVE THE FOLLOWING:A. Installation work and electrical wir-ing must be

Page 2 - PAINTING THE BLOWER

TYPICAL INSTALLATION USING BOSCH HOODSFigure 6 – Remote Blower DimensionsFigure 2 CURB FOR ROOFFigure 3Figure 4Figure 5KITCHEN VENTILATION TIPS1. Coo

Page 3 - POUR RÉDUIRE LES RISQUES

POUR RÉDUIRE LES RISQUESD’INCENDIE, DE CHOCÉLECTRIQUE OU DE BLESSURES,OBSERVER CE QUI SUIT:A. L’installation et le câblage électriquedoivent être eff

Page 4 - PEINDRE LA SOUFFLERIE

INSTALLATION TYPIQUE UTILISANT LES HOTTES BOSCHFigure 2 BORDURE POUR TOITFigure 3Figure 4Figure 5CONSEILS POUR LA VENTILATION1. Les appareils de cuis

Page 5 - MODELO DHG6003UC Y DHG1003UC

ADVERTENCIA- PARA REDUCIREL RIESGO DE UN INCENDIO, DES-CARGA ELÉCTRICA O LESIONES,OBSERVE LO SIGUIENTE:A. Una persona calificada debe realizarlos tr

Page 6 - PINTAR EL VENTILADOR

CONSEJOS DE VENTILACIÓN EN LA COCINA1. Los aparatos electrodomésticos para cocinar como estufas,asadores, parrillas, etc. necesitan una ventilación ad

Page 7

Page 8

Comments to this Manuals

No comments

Bosch DHG1003UC Installation Manual

Browse online or download Installation Manual for Fireplaces Bosch DHG1003UC. Bosch DHG1003UC 1000 CFM Remote Blower Installation instructions User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Fireplaces Bosch DHG1003UC