Bosch SM070 Specifications download pdf (Page 15)

Vertical Configurability | 15SM Series Heat Pump

6 720 220 406 (2013/9)Revised 08-13

Required Tools

• 5/16" hex head driver

• 3/8" hex head driver

• 7/16" hex head driver

• Flat screw driver

• Phillips screw driver

• 1/4" hex head driver

• Needle nose pliers

Access to Internal Components

1. Using a Flat Screw driver remove and retain

Panel Belt by inserting the screwdriver into the

slot and releasing the catch.

(Figures#42and#43)

Figure # 42

Required steps Possible unit configurations

How to use this table:

• Select desired configuration

from “possible unit

configurations”.

• Instructions with “X” have to

be performed to reconfigure

the unit.

Left return,

top discharge

Right return,

top

discharge

Left return,

rear

discharge

Right

return, rear

discharge

Right return,

left

discharge

Left return,

right

discharge

ACCESS TO INTERNAL COMPONENTS

(PG#15)

XXXXX

BLOWER RE-CONFIGURATION (PG#17)

X XXX

E-BOX CONFIGURATION (PG#24)

X XX

ELECTRIC HEAT RELOCATION* (PG#22)

X*

CONDENSATE DRAIN RELOCATION

(PG#20)

X XX

HRP SWITCH* (PG#21)

X* X* X* X*

REINSTALL PANELS (PG#25)

XXXXX

*APPLIES IF OPTION IS INSTALLED

[1] AIR COIL

[2] E-BOX (UNIT FRONT)

[3] BLOWER

X APPLICABLE STEP

All heat pumps are supplied with panel belt

which needs to be removed to access screws

for panel removal. The panels have additional

internal fasteners to prevent any air leakage.

For safety precautions two persons are

required to perform this operation.

The belt is held in place by a clip on one side

and an interference fit on the other end.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 99 100

Comments to this Manuals

No comments