Bosch IntuiKey User Manual download pdf (Page 35)

IntuiKey Keyboard Controlling System4 Video Multiplexers | en 31

Bosch Security System, Inc. User Manual F.01U.127.291 | 1.93 | 2009.03

Softkey Description

Exit Exits the present menu, reverting to the previous menu.

On-screen Menu Provides access to the multiplexer’s on-screen display (OSD), if the access

level has been enabled to FULL ACCESS (otherwise, the softkey display

indicates that the present user level is not high enough for this level of

access). If the current user level does not allow the operation, a warning

message is displayed, and control reverts to the MUX Control submenu. The

warning message clears and reverts to the MUX main control menu in

approximately two (2) seconds or after pressing CLR.

To change the access level, refer to the User Level softkey below.

The on-screen control menu provides softkey access for these multiplexer

functions:

– Exit: ZOOM

Exits to one level higher when in menu mode.

– Choose: SELECT

Used when the OSD prompts to choose a selection.

– Save: SELECT

Used when the OSD prompts to save the current selections.

– Default: FREEZE

Changes an entry to its default state.

– Help

Displays the MUX’s internal help file associated with the present OSD

selection.

– Up ^

Moves the OSD cursor up one line.

– Down v

Moves the OSD cursor down one line.

– < Left

Moves the OSD cursor to the left one position.

– Right >

Moves the OSD cursor to the right one position.

– Enable/Disable

Used in Set Action Zones in the Action Setup menu.

Find MUXes Polls each MUX address for a response. If a response is found, an ON

indicator is displayed next to the MUX address. Exit by pressing any key.

User Level This softkey is used to change the current User Level. (The current setting is

displayed on the softkey.) User Levels can be used to limit access to certain

multiplexer features, including access to the on-screen configuration menu.

To change the current User Level, press the softkey to enter the password

entry mode. Enter the keyboard password (refer to Appendix C) within two

(2) seconds. Select the desired User Level, as listed on the softkey menu.

Note that the selected User Level applies to all multiplexer devices

connected to the IntuiKey.

Quick Keys Allows access to the multiplexer’s quick key commands. If the current user

level does not allow the operation, a warning message is displayed, then

clears and reverts to the MUX main control menu (approximately two (2)

seconds or after pressing CLR). Refer to the Multiplexer Instruction Book

for additional information on the quick key functions.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 49 50

Comments to this Manuals

No comments

Bosch IntuiKey User Manual Page 35

Comments to this Manuals

Related products and manuals for Keyboards Bosch IntuiKey