Bosch D1265 User's Guide download pdf (Page 13)

D1265 | User's Guide | Part II: System Commands

Bosch Security Systems | 9/10 | F01U169131-02 13

Passcode Protected Commands and

Functions

Commands and/or Functions within your system

might be programmed to require a valid passcode

prior to gaining access to that function. This ensures

that only authorized people have access to specific

functions.

1. The display might prompt you to enter your

passcode.

2. The passcode is shown as asterisks (*) when

entered and advance from the right side of the

display to the left until all passcode digits (from

a minimum of 3 to a maximum of six) are

entered.

3. Press ENTER.

Turning the System On (Arming)

Your security system can be turned on (armed) in

many different ways, depending on the arming

command used. Arming Commands are those

commands used to turn the system on. The most basic

arming command is to arm the entire system.

There are several other arming commands to turn the

system on. These are described later in this manual.

To Turn Your Security System On (Arm)

1. Enter your passcode and press ENTER.

2. After you arm your system, the keypad emits a

repeating beep tone, shows Exit now! #

seconds remaining and counts down the exit

delay time.

Turning the System Off (Disarming)

Entering your personal passcode turns off your security

system. When the system is turned on, you must enter

through a designated entry door to prevent an instant

alarm condition. Opening the door starts entry delay

time and the Keypad emits a pulsing “beep” tone to

remind you to turn the system off. Enter your passcode

before the delay time expires and the system turns off.

If you enter through the wrong door or fail to disarm

before the entry delay time expires, you cause an

alarm.

If this happens, silence the alarm (by entering your

personal passcode and pressing ENTER) and call your

security company to let them know that it is not an

emergency situation.

If enabled by your security company,

there is a short period of time after the

start of the alarm that a passcode entry

aborts the transmission of the alarm

report. Alarm Aborted shows if this

occurs.

To Turn Your Security System Off (Disarm):

1. Enter your passcode and press ENTER.

2. You must press the ENTER button within 5 sec

of entering your passcode, or the passcode entry

is invalid.

3. The display returns to idle disarmed text.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Comments to this Manuals

No comments

Bosch D1265 User's Guide Page 13

Comments to this Manuals

Related products and manuals for Numeric keypads Bosch D1265