Bosch D1265 User's Guide download pdf (Page 21)

D1265 | User's Guide | Part II: System Commands

Bosch Security Systems | 9/10 | F01U169131-02 21

Walk Test (CMD + 4 + 4)

Description

Use this function to test keypads, detection devices,

and sounders (both interior and exterior) to be certain

they function properly. You can review untested points

at your keypad to help pin-point any problems.

You cannot arm your system while in the walk test

mode, and no alarm reports are sent to your security

company unless a 24-hr point is activated (such as fire

or panic).

Upon initiation, the walk test tests the burglary bell

pattern on the bell output and rings the keypad

burglary bell for 2 sec. The AC power is disabled for 4

min in order to test the system’s battery power.

If the battery cannot maintain the system for the four-

minute period, the keypad appears to power off. If this

happens, contact your security company. At the end of

the four-minute period, AC is returned to the system

and the control panel restores. To test individual

detection devices, simply activate sensors and open

protected doors and windows one-at-a-time. As each

detection device is faulted, the keypad emits a brief

tone and the display indicates for 60 sec that the point

has been tested. This verifies that each detection device

is working properly.

Using Walk Test

1. Ensure your keypad shows idle text.

2. Press the CMD button. The display shows

*System Command*.

3. Press the 4 button and then the 4 button.

If you prefer, you might use the function

list in place of Steps 2 and 3 to initiate

this function.

Press the Menu button to enter the

function list.

Press the Next button repeatedly.

When you reach the Walk Test button,

press it.

4. The burglary bell sounds for 2 sec. When the

display shows ### points remain to be tested

(### is the number of points) you can begin.

Test each point by first opening and then closing

the door or window, or activating the other

detection device types.

Check the display after testing each point. For

interior points, walking past the device once is

sufficient. If any point will not test correctly,

contact your security company for service.

5. During the Walk Test you might want to refer to

the points that remain untested by pressing the

View untested pts button.

The display shows ### pts untested.

Press the Next Pt or Prev Pt

buttons to refer to

information about specific points that have not

yet been tested.

6. Move through this list by pressing the Next Pt

button.

The display changes to show the information for

that point.

Press the Exit button to return to the ### points

remain to be tested screen before continuing

with the walk test.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 35 36

Comments to this Manuals

No comments

Bosch D1265 User's Guide Page 21

Comments to this Manuals

Related products and manuals for Numeric keypads Bosch D1265