Bosch GPO 14 CE Professional Operations Instructions download pdf (Page 21)

22 | English

1 609 929 T45 | (27.11.09) Bosch Power Tools

Robert Bosch GmbH, Power Tools Division

D-70745 Leinfelden-Echterdingen

06.11.2009

Assembly

Mounting the Protective Devices

f Before any work on the machine itself, pull

the mains plug.

Auxiliary Handle

f Operate your machine only with the auxilia-

ry handle 5.

Screw the auxiliary handle 5 on the right or left

of the machine head depending on the working

method.

With the handle extension 4, the auxiliary han-

dle 5 can be mounted above the gear head, pro-

viding a favourable centre of gravity. Depending

on the working manner, screw the handle exten-

sion 4 to the right or left on the gear head.

Hand Guard

When working without the handle extension 4,

the hand guard 9 should be mounted.

The hand guard 9 is fastened with the auxiliary

handle 5.

Protective Cap for Gear Head

The gear head warms up when working with the

machine. The protective cap 1 can be used as a

contact protector.

Mount the protective cap 1 onto the gear head

and fasten it with fastening screw 2 and the aux-

iliary handle 5.

Mounting the Grinding Tools

f Before any work on the machine itself, pull

the mains plug.

Clean the grinder spindle 10 and all parts to be

mounted.

For clamping and loosening the grinding tools,

lock the grinder spindle with the spindle lock

button 3.

f Actuate the spindle lock button only when

the grinder spindle is at a standstill. Other-

wise, the machine may become damaged.

See graphics page for the mounting sequence.

Buffing Disc

Screw the clamping mandrel 11 firmly onto

grinder spindle 10 and tighten it via the spanner

surfaces with an open-end spanner.

Mount the clamping flange 12 and the buffing

disc 13 onto the clamping mandrel 11. Screw on

the clamping nut 14 and tighten with the two-

pin spanner.

Polishing Sponge

Screw the polishing sponge 15 firmly onto the

grinder spindle 10. The lambskin polishing bon-

net 16 can be pulled over the polishing sponge

15.

Rubber Sanding Plate

Place the rubber sanding plate 17 onto the

grinder spindle 10.

Screw on the round nut 19 and tighten with the

two-pin spanner.

Firmly press the sanding sheet 18 onto the bot-

tom side of the rubber sanding plate 17.

Felt Polishing Disc

Firmly screw the felt polishing disc 20 onto the

grinder spindle 10.

Cup Brush/Disc Brush

The cup brush/disc brush must be able to be

screwed onto the grinder spindle until it rests

firmly against the grinder spindle flange at the

end of the grinder spindle threads. Tighten the

cup brush/disc brush with an open-end span-

ner.

Dr. Egbert Schneider

Senior Vice President

Engineering

Dr. Eckerhard Strötgen

Head of Product

Certification

OBJ_BUCH-1139-001.book Page 22 Friday, November 27, 2009 11:44 AM

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 132 133

Comments to this Manuals

No comments