Bosch DVA-12T Installation Manual download pdf (Page 18)

18 en | Hardware Installation RAID Subsystem DVA-12T | Installation Manual

F.01U.027.798 | V1 | 2006.06 Bosch Security Systems

Installation Procedure Flowchart

Table 3.1 shows a flowchart of the installation procedure. As you complete each step, check

off the “Done” box on the right. Please use this flowchart in conjunction with the instructions

that follow.

3.5 Unpacking the Subsystem

Use the Unpacking Checklist in your package to verify package contents. Carefully check the

items contained in each box before proceeding with installation.

3.6 Rack/Cabinet Installation

The 2U RAID subsystem has been designed to fit into a standard cabinet or rack. Two (2) slide

rails are available for installing the subsystem into a rack or cabinet (see

Section 8.2 Accessories). The subsystem should be installed in the rack or cabinet before the

hard drives and the drive trays are installed. If the drive trays with the associated hard drives

are installed, the subsystem will be too heavy to mount into a rack or cabinet. When installing

the subsystem into a rack or cabinet it is advisable that three (3) people assist in the mount-

ing process.

To install the subsystem into a rack or cabinet, please refer to the installation instructions that

came with the slide rails.

3.7 Drive Tray Installation

Once the hard drives have been installed in the drive trays, the drive trays can be installed into

the RAID subsystem.

1. All drive trays must be installed into the enclosure even if they do not contain a hard

drive. If the trays are not installed into the enclosure, the ventilation required for cooling

will not be normalized and the subsystem will overheat. Make sure the key-lock is in the

unlocked position, i.e., the groove on its face is in a horizontal orientation. If the groove is

in a vertical position, then the key-lock is locked and the front flap on the drive tray can-

not be opened.

Installation Procedure Done

1Unpack See Section 3.5 Unpacking the Subsystem

2 Rack/Cabinet Installation See Section 3.6 Rack/Cabinet Installation

5 Drive Tray Installation See Section 3.7 Drive Tray Installation

6 Cable Connection

7 Power On See Section 5.3 Power On

Table 3.1 Installation Procedure Flowchart

NOTICE!

A detailed packing list can be found in your product shipping package or product CD.

CAUTION!

All drive trays must be installed into the enclosure even if they do not contain a hard drive. If

the trays are not installed into the enclosure, the ventilation required for cooling will not be

normalized and the subsystem will overheat.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 55 56

No comments

Bosch DVA-12T Installation Manual Page 18