Bosch DVA-12T Installation Manual download pdf (Page 19)

RAID Subsystem DVA-12T | Installation Manual Hardware Installation | en 19

Bosch Security Systems F.01U.027.798 | V1 | 2006.06

Fig. 3.1 Front View of an Individual Drive Tray

2. Open the front flap on the drive tray. (See Figure 3.2) Push the release button on the front

of the drive tray. The front flap will open in an upward direction.

Fig. 3.2 Drive Tray Front Flap

3. Align the drive tray with the slot in which you wish to insert it. Make sure that it is resting

on the rails inside the enclosure. Once the drive tray is lined up with the slot, gently slide

it in. This should be done smoothly and gently. (See Figure 3.3)

Fig. 3.3 Installing a Drive Tray

4. Close the front flap on the drive tray. Make sure the front flap is closed properly to ensure

that the SATA connector at the back of the drive tray is firmly connected to the corre-

sponding connector on the backplane board. If the front flap is not closed properly, the

connection between the hard drive and the subsystem will not be secure.

5. Lock the flap into place by turning the key-lock until the groove on its face is pointing

down (vertical orientation). (See Figure 3.4)

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 55 56

No comments

Bosch DVA-12T Installation Manual Page 19