Bosch UNPC Series Instruction Manual Page 9

  • Download
  • Add to my manuals
  • Print
  • Page
    / 12
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 8
EN
|
9
Bosch Security Systems | 07 June 2004
5INSTALLATION
ATTENTION: Installation should be done by
qualified service personnel, and should
conform to the National Electrical Code
and applicable local codes.
5.1 Operating Voltage
Recommended operating voltage is 24 VAC, 60 Hz.
5.2 Preparing the Unit
Remove the mount and housing assembly from the
carton.
5.3 Mount
Prepare and secure the mount to the wall or mounting
surface as described in the LTC 9215/00 Installation
Manual included in the Installation Document Packet.
5.4 Housing
Feed the cabling from the housing foot through the
mount. Attach the housing to the mount using the
two (2) M6 screws and washers provided in the
hardware kit. For additional information, refer to
the LTC 9215/00 Mount Installation Manual and
LTC 948x Series Housing Installation Manual.
5.5 Line Power and Video Signal
Connection
The external video coax cable is equipped with a
female BNC connector for transmission of video.
Route and connect video cable to the BNC connector.
The external power cable is provided to allow for
necessary stripping/preparation by the installer. For
additional information, refer to the Installation
Manuals included in the Installation Document Packet.
6 CAMERA/LENS
ADJUSTMENT
The camera and lens come factory configured and
ready for operation. If custom setup is required, refer
to the camera Installation Instructions included in the
Instruction Booklet Packet.
7SUNSHIELD
An LTC 9083/01 Sunshield is provided with the
outdoor packages. Refer to the Sunshield Installation
manual for information.
UNPM, UNPC, UNPDN, UNPXF Series | Instruction Manual | Installation
Page view 8
1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments