Bosch VideoJet 8008 User Manual download pdf (Page 113)

VideoJet 8008 | Installation and Operating Manual

EN | 113

Bosch Security Systems | 2005-06 | V2.0 Operation

Hardware connections between video servers

A VideoJet 8008 with a camera connected to it can be used as a transmitter and

a compatible MPEG-4 hardware decoder (such as the VIP XD) with a

connected monitor as a receiver using an Ethernet network connection. This

way it is possible to cover large distances with little effort for installation or

cabling.

Installation

The compatible video servers are designed to connect with one another

automatically with the corresponding configuration. This only requires that they

be part of a closed network. Proceed as follows to install the devices:

– Connect the devices to the closed network using Ethernet cables.

– Connect them to the mains supply.

Note

Make sure the devices are configured for the network environment and the

correct IP address for the remote location to be contacted in the event of

an alarm is set in the Alarm connections field (see pages 51 and 85).

Establishing the connection

There are three options for establishing a connection between a transmitter and

a compatible receiver in a closed network:

] an alarm,

] a terminal program or

] a web browser

Connect on alarm

With the appropriate configuration, a connection between a transmitter and a

receiver is established automatically when an alarm is triggered (see page 85).

After a short time, the live video image from the transmitter will be shown on the

connected monitor.

This connection option can also be used to connect a VideoJet 8008 and a

compatible receiver using a switch connected to the alarm input. In this case, no

computer is needed to establish the connection.

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 135 136

No comments

Bosch VideoJet 8008 User Manual Page 113