VideoJet 8008 | Installation and Operating Manual
EN | 25
Bosch Security Systems | 2005-06 | V2.0 Installation
– Enter the desired IP address and press Enter. The new IP address will be
shown.
– If necessary, enter the command s and a new subnet mask.
Note
The new IP address and a new subnet mask or gateway address will only
be valid after restarting.
Restart
Briefly disconnect the power supply to the VideoJet 8008 (remove connector
and re-connect after a few seconds).
Additional parameters
Using the terminal program, you can check other basic parameters and modify
them where necessary. Use the on-screen commands displayed in the various
submenus to do this.
Comments to this Manuals