Bosch GWS 8-125 C (CE) Operations Instructions Page 14

  • Download
  • Add to my manuals
  • Print
  • Page
    / 124
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 13
English | 15
Bosch Power Tools 1 609 929 L33 | (24.7.08)
Use dust extraction whenever possible.
Provide for good ventilation of the working
place.
It is recommended to wear a P2 filter-class
respirator.
Observe the relevant regulations in your coun-
try for the materials to be worked.
Operation
Starting Operation
f Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine.
When operating the machine with power from
mobile generators that do not have sufficient re-
serve capacity or are not equipped with suitable
voltage control with starting current amplifica-
tion, loss of performance or untypical behavior
can occur upon switching on.
Please observe the suitability of the power gen-
erator being used, particularly with regard to the
mains voltage and frequency.
Switching On and Off
To start the power tool, push the On/Off switch
2 forwards.
To lock the On/Off switch 2, press the On/Off
switch 2 down at the front until it latches.
To switch off the power tool, release the On/Off
switch 2 or, if it is locked, briefly push down the
back of the On/Off switch 2 and then release it.
f Check grinding tools before using. The grind-
ing tool must be mounted properly and be
able to move freely. Carry out a test run for
at least one minute with no load. Do not use
damaged, out-of-centre or vibrating grinding
tools. Damaged grinding tools can burst and
cause injuries.
Reduced starting current
The electronic reduced starting current limits the
power consumption when switching the tool on
and enables operation from a 13 ampere fuse.
Constant Electronic Control
Constant electronic control holds the speed con-
stant at no-load and under load, and ensures uni-
form working performance.
Speed preselection (GWS 8-100 CE/GWS 8-125 CE/GWS 850 CE)
The required speed can be preselected with the thumbwheel 4 (also while running).
The data in the following table are recommended values.
Material Application Accessory Thumbwheel
Position
Metal Removing paint Sanding disc 2
3
Wood, metal Brushing, rust removal Cup brush, sanding disc 3
Metal, masonry Grinding Grinding disc 4
6
Metal Rough grinding Grinding disc 6
Masonry, stone Cutting Cutting disc and cutting guide
(Cutting masonry/stone is permitted only
with use of the cutting guide)
6
OBJ_DOKU-12526-003.fm Page 15 Thursday, July 24, 2008 1:38 PM
Page view 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 123 124

Comments to this Manuals

No comments