Bosch TSTBM3H2CPH6W-A Installation Manual Page 26

  • Download
  • Add to my manuals
  • Print
  • Page
    / 32
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 25
6 720 220 376
Subject to change without prior notice Revised 02-13
26 TSTBM3H2CPH6W-A
8. There are a total of 4 programmable times. After
you have set the “Waketime above, set the
remaining three; “Leave”, Return, and Sleep
Repeat steps 4 through 7 for weekday LEAVE
time period, for weekday RETURN time period,
and for weekday SLEEP time period.
Saturday:
9. Repeat steps 4 through 7 for Saturday WAKE
time period, for Saturday LEAVE time period, for
Saturday RETURN time period, and for Saturday
SLEEP time period.
Sunday:
10. Repeat steps 4 through 7 for Sunday WAKE time
period, for Sunday LEAVE time period, for
Sunday RETURN time period, and for Sunday
SLEEP time period.
Set 7 Day Program Schedule
To customize your 7 day program schedule, follow
these steps:
Monday:
1. Select HEAT or COOL using the SYSTEM key.
You have to program heat and cool each
separately
2. Press MENU
3. Press SET SCHED
Monday-Friday is displayed and the WAKE
icon is shown. You are now programming the
wAkE time period for the Monday setting.
Additional step if TSTBM-RRS--TW-A
indoor remote sensor is connected.
The TSTBM3H2CPH6W-A master thermostat will
either average all sensors (system average) or
only use one sensor for the system ambient
temperature (priority). The default setting is
SYSTEM AVERAGE, which means all sensors are
averaged to create the system average ambient
temperature reading. The NEXT ZONE key can
be pressed to change the priority. The system
information area of the display shows the
priority.
For Example: There is an TSTBM-RRS--TW-A
connected and it is named REMOTE 1. If the
NEXT ZONE key is pressed until REMOTE 1 is
shown, then the REMOTE 1 ambient
temperature reading will be used exclusively for
that time period. All other sensors will be
ignored.
4. Time is ashing. Use the [+] or [–] key to make
your time selection for the Monday WAKE time
period.
Caution
If you want the fan to run continuously
during this time period, select ON
with the FAN key
5. Press NEXT STEP
6. The setpoint temperature is ashing. Use the [+]
or [–] key to make your setpoint selection for the
Monday WAKE period.
7. Press NEXT STEP
8. Repeat steps 4 thru 7 for Monday LEAVE time
period, for Monday RETURN time period, and for
Monday SLEEP time period.
Tuesday, Wednesday, Thursday, Friday, Saturday,
Sunday:
Repeat steps 4 thru 7 for the remaining days of the
week.
Caution
Auto changeover will switch between heating
and cooling as needed. It is very important to
make sure the cooling setpoint temperature
is at least 3º above the heating setpoint
temperature and that the heating setpoint
temperature is at least 3º below the cooling
setpoint temperature.
Caution
The programmable fan feature will run the
fan continuously during any time period it is
programmed to be on. This is the best way to
keep the air circulated and to eliminate hot
and cold spots in your building.
Setting 5+1+1 Program
Page view 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments