Bosch TSTBM3H2CPH6W-A Installation Manual download pdf (Page 4)

6 720 220 376

Subject to change without prior notice Revised 02-13

4 TSTBM3H2CPH6W-A

INSTALLATION TIPS

REMOVING THE PRIVATE LABEL BADGE

Gently slide a scredriver into the bottom edge of the

badge. Gently trun the screwdriver counter

clockwise. The badge should pry off easily. Do not

use force.

Caution

All Bosch thermostats use the same

universal magnetic badge. Contact your local

Bosch distributor to learn more about our

free private label program.

WALL LOCATIONS

The thermostat should be installed approximately 4

to 5 feet above the oor. Select an area with average

temperature and good air circulation.

Do not install thermostats in locations that are:

• On an exterior wall

• In direct sunlight

• Where there may be concealed chimneys or pipes

behind the wall

• Close to a window or door leading outside

• Close to objects radiating heat such as replaces,

lighting, space radiators, or any other appliance

• In areas that do not require conditioning

• In dead spots or where drafts can occur (behind

doors or in corners)

• Close to hot or cold air ducts

Caution

Pick an installation location that is easy for

the user to access. The temperature of the

location should be representative of the

building.

Installation Tips

THERMOSTAT QUICK REFERENCE

Program Menu Options:

Shows different options

during programming.

Wireless Icon

Temperature:

Indicates the current

system temperature.

Humidity:

Shows the humidity target

setpoint settings and keys.

Low Battery Indicator:

Replace batteries when

this indicator is shown.

Programmable Time

Period Icons:

This thermostat has

4 programmable

time periods per day.

Clean Display:

Pressing CLEAN DISPLAY

will allow 30 seconds to clean

the display. The keys will be

inoperable during this time.

CLEAN will appear if your

contractor has programmed a

ﬁlter change reminder. Press

CLEAN when ﬁlter has been

replaced to reset the ﬁlter

change reminder timer.

Displays the user selectable

setpoint temperature.

System operation indicators:

COOL HEAT FAN

Days of the week and time. Flashes ambient

humidity level. May also ﬂash outside temperature

when used with TSTBM-OTS--TW-A. OUTDOOR will show.

On the back of the thermostat insert 2 AA Alkaline

batteries (included).

Pull the thermostat directly away from the wall to

access the batteries. A ﬁrm tug will be required

to remove the thermostat from the subbase

mounted on the wall.

REMOTE indicates a remote

has control of the system.

HOLD is displayed when thermostat

program is permanently overridden.

The COOL, HEAT or FAN icon will display

when the COOL, HEAT or FAN is on.

NOTE: The compressor delay feature is

active if these icons are ﬂashing. The

compressor will not turn on until the

5 minute delay has elapsed.

Additional Stages of Heating or Cooling;

+1 represents 1 additional stage of

cooling or heating (2 total); +2 means

2 additional stages of heating (3 total)

System Information:

Shows which zone or zones are

controlling your system. Shown only

when one or more indoor sensors

TSTBM-RRS--TW-A are connected.

1 2 3 4 5 6 7 8 9 ... 31 32

Comments to this Manuals

No comments

Bosch TSTBM3H2CPH6W-A Installation Manual Page 4

Comments to this Manuals