Bosch 583 DDC User Manual download pdf (Page 5)

| 5

Quick Start Guide Subject to change without prior notice 8733914716 DDC (2014/02)

Quick Start Guide

GETTING STARTED

Perform a quick visual inspection to ensure the

controller has no external damage and all connectors

are intact. Ensure wiring is per desired application

(see sample FHP 560 wiring diagram on page 14).

Refer to I/O port conguration (page 13) for further

details on wiring inputs and outputs.

JUMPER SETTINGS

Verify that hardware conguration for jumpers

match corresponding Heat Pump system

application. If the controller is networked, ensure

communications jumper is set to EIA-485, unless

the network protocol is BACnet over ARC156.

Getting Started

Input Selection Jumpers for IN-1 & IN-2

(e.g. for a 0-5V CO2 Sensor

connected to IN-1, the jumper

should be set in bottom position)

IN-1 & IN-2 Jumper

Settings Label

Communications Selection Jumper

(i.e. jumper in bottom position for

BACnet over ARC156, or, jumper in top

position for EIA-485 using BACnet over

MS/TP, LON, Modbus, or N2 protocols)

Communications Selection label

In the above diagram, IN-1 and IN-2 are set to Thermistor/Dry

Contact, and Communications is set to BACnet over ARC156.

1 2 3 4 5 6 7 8 9 10 ... 15 16

No comments

Bosch 583 DDC User Manual Page 5