Bosch SMD500 Datasheet download pdf (Page 18)

Application Note

BlueBox Demo-Board for the digital sensors

SMB365 (acceleration) and SMD500 (pressure)

Bosch Sensortec

AN18002

Rev. 1.0

Page 18

hts even in the event of industrial propert

hts. We reserve all ri

hts of disposal such

cop

and passin

onto third parties.

7211RB11.

4. After starting the software, the cockpit window of the BlueBox software appears. The

software tries to locate automatically the corresponding COM port of the demo board. If

the demo board is located, a status message at the bottom left hand corner of the

software window will indicate to which COM port the module is connected. If the status

window indicates “Module not found” the board has to be located manual. Only in this

case click on “File” Æ “Detect Module on COM Port” in the status bar.

5. Press the „Start“ button to start data acquisition of acceleration and pressure sensor

6. Accelerate, roll, tilt or lift the BlueBox board

7. Watch the graphs in the different displays on the cockpit screen

o Note: For exact altimeter response it is strongly recommended to correct the

ambient air pressure data before further using the board (see chapter 3.3)

Status window

Select „File“ Æ “Detect Module on COM Port” for manual COM port location

Start data acquisition

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 45 46

No comments

Bosch SMD500 Datasheet Page 18