Bosch SMD500 Datasheet Page 20

  • Download
  • Add to my manuals
  • Print
  • Page
    / 46
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 19
Application Note
BlueBox Demo-Board for the digital sensors
SMB365 (acceleration) and SMD500 (pressure)
Bosch Sensortec
AN18002
Rev. 1.0
Page 20
© Bosch Sensortec GmbH reserves all ri
g
hts even in the event of industrial propert
y
ri
g
hts. We reserve all ri
g
hts of disposal such
cop
y
in
g
and passin
g
onto third parties.
7211RB11.
9. After starting the software, the cockpit window of the BlueBox software appears. The
software tries to locate automatically the corresponding virtual COM port of the demo
board. If the demo board is located, a status message at the bottom left hand corner of
the software window will indicate, to which COM port the module is connected. If the
status window indicates “Module not found” the board has to be located manually. Only
in this case click on “File” Æ “Detect Module on COM Port” in the status bar.
10. Press the „Start“ button to start data acquisition of acceleration and pressure sensor
11. Accelerate, roll, tilt or lift the BlueBox board
12. Watch the graphs in the different displays on the cockpit screen
o Note: For exact altimeter response it is strongly recommended to correct the
ambient air pressure data before further using the board (see chapter 3.3)
Status window
Select „File“ Æ “Detect Module on COM Port” for manually COM port location
Start data acquisition
Page view 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 45 46

Comments to this Manuals

No comments