Bosch BC3200RA5 Service Manual download pdf (Page 11)

3/4” PVC pipe

Casing Dimensions

Connection Measurements

Outdoor clearances to doors & windows

Outdoor installations should have the minimum clearances

shown below to ensure that ﬂue exhaust cannot enter into

surrounding buildings.

Pipework Connections

A Hot water outlet 3/4”

B Cold water inlet 3/4”

C Gas connection 3/4”

D Condensate outlet 1/2”

Connection dimensions

condensate drain from freezing by installing insulation,

heat tape or electric heaters.

Important points to consider when siting a condensate

drainage pipe

3 Ensure the plastic piping is no smaller than ¾” in

diameter

3 Use plastic pipe. Do not use steel, black iron or other

corrodible material

3 Keep the length of the drainline as short as possible

3 Horizontal runs must be sloped 1/50 downwards

towards the drain

3 The drain end should not be submerged in water or

blocked in any way

Condensate pipework

This system is supplied with a pre-installed condensate

neutralisation system. This neutraliser will remove any

acidity that is present in the condensate. This means that

no further steps are required to treat the condensate,

unless local laws specify otherwise.

In colder areas, considerations should be taken in order

to stop the drainline from freezing. If the temperature is

likely to drop below 0°C, take measures to prevent the

Technical & Speciﬁcation Information – Bosch 32 Series Water Heaters

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 59 60

No comments

Bosch BC3200RA5 Service Manual Page 11