Bosch MUM 7000 UC Owner's Manual download pdf (Page 13)

13

The dough hook should be used for all

heavier substances such as cookie doughs,

yeast doughs, pastry doughs and other

heavy doughs.The dough hook should

always be used when adding nuts,

chocolate chips, dried fruits, hard butter or

other fats, hardened brown sugar, etc. to a

mixture.

Use of mixing bowl with twin beating whisks

Before beginning to attach this or any other

attachment, make sure that the power unit

is on a smooth, clean, suitable surface and

switched to off position, “O/Off,” and that

you have removed the motor drive cover.

1. Before using the mixing bowl and twin

beating whisk assembly for the first

time, it is recommended that the bowl,

anti-splash cover, filling funnel cap and

twin beating whisk assembly be

washed. All components of the mixing

bowl and the twin beating whisk

assembly are dishwasher safe, except

the whisk holder.

The whisks may be removed from the

whisk holder as shown in figure 9a, and

washed in the dishwasher along with

the mixing bowl and other components.

The whisk holder should be washed in

warm soapy water. After washing, rinse

well and dry the whisk holder before

reattaching the whisks as shown in

figure 9b.

The driveshaft should also be removed

from the mixing bowl for cleaning, if it

has not already been done. See

previous section, covering mixing bowl

and dough hook, for instructions on how

to remove driveshaft.

2. If you have not already done so, remove

the motor drive cover and place the

mixing bowl on the mono drive of the

power unit and turn the bowl counter-

clockwise with a slight downward

pressure until bowl is firmly seated on

the mono drive coupling, see figure 4.

CAUTION

Failure to make sure that the bowl is

properly seated on the mono drive coupling

before the power unit is turned on can result

in damage to the bowl and/or coupling.

3. Place and engage the twin beating

whisk assembly on the driveshaft of the

mixing bowl as shown in figure 10a.

Figure 10.

4. Place the anti-splash cover on the bowl

so that the tabs on the bowl fit into the

recesses in the cover, and turn the anti-

splash cover counterclockwise to

fasten the bowl cover to the bowl.

See figure 10b.

The anti-splash cover has an integral filling

funnel with a cap. The cap may be removed

a. b.

Figure 9.

a. b.

1 2 ... 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments