Bosch AutoDome User Manual download pdf (Page 7)

AutoDome Modular Camera System Ge t t i n g St a r ted | e n 3

Bosch Security Systems, Inc. VG4-100 Series User’s Manual F01U028033 | 2.0 | 2007.03

1 Getting Started

Install and wire the 100 Series AutoDome according to the AutoDome Modular Camera System

Installation Manual. A typical system includes a keyboard, matrix switcher, monitor, and appro-

priate wiring connections. Please refer to the individual product manuals for complete instal-

lation and setup instructions for each of the system components.

2 Camera Setup

To assist setup, the VG4-100 Series camera module can be connected to a monitor through

the miniature 2.5 mm monitor jack located on the camera circuit board. The monitor jack pro-

vides a composite video signal with synchronization. An optional cable (part number S1460,

SAP No. F01U500418) is available for making this connection.

To access the monitor jack, remove the bubble and covert liner:

1. Insert a small screw driver through the keyway in the Pendant trim-ring, rotate the dome

bubble counterclockwise and remove the dome bubble. For In-Ceiling AutoDomes, you

must loosen the small screw in the trim ring before rotating the bubble.

2. Press and hold the two retention buttons on each side of the camera module and then

pull off the covert liner. See Figure 2.1 below.

Removing the covert liner provides access to the menu keys, and the pan and tilt thumbscrew

adjustment locks. See Figure 3.1 on page 4.

Fig. 2.1 100 Series Camera Module

Covert Liner

Retention

Buttons (2)

Menu Keyboard

Monitor Jack

FRONT VIEW

BACK VIEW

Retention

Button (2)

Back View

Menu Keyboard

Monitor Jack

Front View

Covert Liner

1 2 3 4 5 6 7 8 9 10 11 12 ... 41 42

No comments

Bosch AutoDome User Manual Page 7