Bosch Appliances Security Camera LTC 9449 User Manual download pdf (Page 10)

LTC 9449 Series Camera Line | Instruction Manual | Camera Setup

Bosch Security Systems | October 10, 2006

4.4 Connections for F Suffix and

N Suffix Models

Connections for models containing fiber optic or

twisted pair interfaces are defined in a separate

Addendum, provided with those model types.

4.5 Dome Removal

1. Remove the bottom piece of the dome by vertically

pulling on the lower half. A safety strap prevents

the bottom from dropping.

2. The cameras used in the LTC 9449 Unity Dome

Series can be adjusted in a variety of ways; refer to

Section 5 for more information.

3. Reattach the dome's bottom half by aligning up its

tabs and vertically inserting the unit into the top

half until it snaps into place.

4. Adjust the dome bubble to align the viewing slot

with the camera.

5 CAMERA SETUP

5.1 Camera/Lens Positioning

The camera mounting brackets allow for camera view

adjustments in the X (pan), Y (tilt), and Z (diagonal)

planes. Be sure that the alignment indicator on the

camera mounting bracket is pointing in an upward

direction.

Figure 5: Camera/Lens Positioning

1. X (Pan) Adjustment:

a. The camera may be rotated by grasping

the slotted bracket, just above the two

wing nuts, and twisting it from

side to side.

2. Tilt (Y) Adjustment:

a. Loosen the wing nut on the side bracket

to adjust camera tilt. Pliers may be

required to loosen it since the unit is

shipped with the wing nut tightened.

b. Tilt the camera to the desired position.

The camera depth can be adjusted at the

same time, by moving the camera along

the slots.

c. Be sure that the camera alignment is

correct. The alignment indicator should

be pointing in an upward direction (see

FIGURE 4).

4. Diagonal (Z) Adjustment:

a. Loosen the two diagonal adjustment

screws.

b. Grasp the slotted bracket just above the

two wing nuts, and twist the bracket

along the two curved slots. To prevent

pan (X-plane) movement, hold the long

bracket below the wing nuts with your

other hand.

c. Tighten the two diagonal adjustment

screws.

5. Be sure that all adjustment nuts are tight after

completing camera positioning.

5.2 Lens Varifocal Range Adjustment

These models are provided with either a 3-8mm or

5-50mm varifocal DC auto iris lens.

Adjust focal range to the desired view, as with any

varifocal type lens.

Diagonal (Z)

Adjustment

Screw

Alignment

Indicator

Wing Nut

for Adjusting

Tilt (Y) & Depth

Wing Nut

for Adjusting

Tilt (Y) & Depth

Camera

Mounting

Screw

Diagonal (Z)

Adjustment

Screw

1 2 ... 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Bosch Appliances Security Camera LTC 9449 User Manual Page 10

Comments to this Manuals

Related products and manuals for Camera housings Bosch Appliances Security Camera LTC 9449