Bosch TES80323RW Instruction Manual download pdf (Page 25)

21

TES80.. | 04/2013

en

Descaling

Duration: approx. 30 minutes.

Cleaning and service

Descale



start

Clean

The

start

button 8 ashes while the different

descaling processes are running.

The gures on the top right indicate the

progress of the programme.

Important: If there is a water lter 29 in

the

water tank 11, it needs to be removed

before the service programme is run.

● Press the à button 3.

Descale



start

● Press the start button 8; the display 5 will

guide you through the programme.

Empty drip tray

Replace drip tray

● Empty the drip tray 23 and reinsert it.

Place 1 l container

Place suction pipe in container



start

● Place a container with 1 litre capacity

under

the milk frother 10.

● Place the end of the suction pipe 10d in

the container.

● Press the start button 8.

Remove filter



start

Info: If the water lter 29 is activated, the

display will prompt you to remove the lter

29, then press the start button 8 again.

Add 0.5 l water and descaler



start

● Pour lukewarm water into the empty water

tank

11 up to the “0.5 l” mark and then

dissolve two Bosch descaling tablets in it.

● Press the start button 8. The descaling

programme will now run for about

20 minutes.

Descaling

Not enough descaling fluid.

Refill fluid



start

Info: If there is not enough descaling solu-

tion in the

water tank 11, the corresponding

prompt is displayed. Pour in descaling solu-

tion

and press the start button 8 again.

Clean and refill water tank



start

● Rinse the water tank 11 and rell it with

fresh

water up to the “max” mark.

● Press the start button 8. The descaling

programme now runs for about 1 minute

and rinses the appliance.

Descaling

Empty drip tray

Replace drip tray

● Empty the drip tray 23 and reinsert it.

Replace the lter if one is being used. The

appliance is ready for use again.

Important: Wipe down the appliance

using a soft, damp cloth to immediately

remove any descaler residue. Such residue

can cause corrosion. New sponge cloths

may contain salts. Salts can cause rust

lm on stainless steel and must therefore

be washed out thoroughly before use.

Thoroughly clean the suction pipe 10d of

the milk frother.

TES803_805_807_1RW.indb 21 08.05.2013 14:53:02

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 167 168

Comments to this Manuals

No comments