Bosch TIS30159DE Instruction Manual download pdf (Page 40)

en Settings

40

Setting the water hardness

It is important to set the water hardness

correctly so that the appliance indicates

in good time when the descaling

programme should be run. The preset

water hardness is level 4.

You can check the water hardness

using the enclosed test strip or by

asking your local water supplier.

1. Briefly immerse the enclosed test

strip in fresh tap water, leave it to

drip and read off the result after one

minute.

2. Press and hold % and

Calc’nClean for at least 3 seconds.

3. Touch Espresso button, and

"W. hardness" will be activated.

4. Touch % button and select the

water hardness.

The following settings are possible:

5. Touch Espresso button to save the

setting.

6. Touch Calc’nClean button to exit the

menu.

The table shows the allocation of the

levels to the different degrees of water

hardness:

Subsequent changes to the water

hardness can be made at any time.

Note: When using the water filter (see

section "Accessories"), proceed as

follows. ~ "Water filter" on page 38

Factory reset

If you set the appliance back to the

factory settings, you will lose your own

settings.

1. Press and hold % and

Calc’nClean for at least 3 seconds.

2. Touch Latte Macchiato button.

The factory settings are reactivated.

3. Touch Calc’nClean button to exit the

menu.

W. hardness 1

W. hardness 2

W. hardness 3

W. hardness 4 (factory setting)

Water filter (when used)

H2O-Softener (if available)

Level Degree of water hardness

German (°dH) French (°fH)

1 1-7 1-13

2 8-14 14-25

3 15-21 26-38

4 22-30 39-54

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 99 100

Comments to this Manuals

No comments