Bosch DWA061450 Installation Manual download pdf (Page 14)

14

Replacing the light bulbs

Warning! Prior to touching the light bulbs

ensure they are cooled down.

1. Switch off the extractor hood and pull out

the mains plug or switch off the electricity

supply at the fuse box.

2. Remove the lamp cover, use a flat bladed

screw driver as a lever.

3. Replace the bulb (use only Halogenlamp

max. 20 Watt - G4 ).

4. Attach the lamp cover again.

5. Plug the appliance into the mains or

switch it on at the fuse box.

If you encounter a problem

If you have any questions or if a fault occurs,

please call Customer Service. (See list of

Customer Service representatives).

When you call, please quote the following:

E-Nr. FD

Enter the relevant numbers into the box

above.

The E-Nr. (product no.) and FD (production

date) are shown on the name plate which

can be seen inside the extractor hood after

the filter frame has been detached.

Cleaning and care

Disconnect the extractor hood from the

electricity supply by pulling out the mains

plug or switching it off at the fuse box.

❑ At the same time as you clean the grease

filters, clean off any grease from all

accessible parts of the housing. This

significantly reduces the fire hazard and

ensures that the extractor hood performs

as effectively as possible.

❑ Use a hot detergent solution or a mild

window cleaner to clean the canopy of the

extractor hood.

❑ Do not scrape off any dirt that has dried

on but loosen it up with a damp cloth.

❑ Do not use abrasive cleaning agents or

sponges that could cause scratches.

❑ Note: Do not use alcohol (spirit) on

plastic parts, otherwise the surface may

become matt in appearance.

Caution: Ensure that the kitchen is

adequately ventilated. Avoid naked

flames!

Clean the sliding switch with a soft,

damp cloth (mild detergent solution) only.

Do not use stainless steel polish on the

sliding switch.

Stainless steel surfaces:.

❑ Use a mild non-abrasive stainless steel

cleaner.

❑ Clean the surface in the same direction

as it has been ground and polished.

Do not use any of the following to clean

stainless steel surfaces: abrasive sponges,

cleaning agents containing sand, soda, acid

or chloride!

Aluminium and plastic surfaces:

❑ Use a soft, non-linting window cloth or

micro-fibre cloth.

❑ Do not use dry cloths.

❑ Use a mild window cleaning agent.. Do

not use aggressive, acidic or caustic

cleaners.

❑ Do not use abrasive agents.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 75 76

Comments to this Manuals

No comments