Bosch Isio Service Manual download pdf (Page 12)

English | 25

Bosch Power Tools F 016 L70 633 | (5.8.10)

The battery charge-control indicator 2 indicates

the charging progress. During the charging proc-

ess, the indicator flashes green. When the bat-

tery charge-control indicator 2 lights up green

continuously, the battery is fully charged.

During the charging procedure, the handle of

the garden product warms up. This is normal.

Disconnect the battery charger from the mains

supply when not using it for longer periods.

The garden product cannot be used during the

charge procedure; it is not defective when inop-

erative during the charging procedure.

f Protect the battery charger against mois-

ture!

Pole cart (accessory or supplied with

“Grass Shear & Pole Cart”)

f The pole cart is designed only for use with

the grass shear at ground level.

f Do not use the pole cart with the shrub

shear or above ground level.

Removing Pole Cart (see figure B)

Fitting Pole Cart (grass shear only)

Align the grooves on the garden product with

fixing on the wheel cart 12.

Plug in the handle connector 10.

Adjusting Handle Length (see figure C)

Adjusting for Edging Mode (see figure D)

Turn the garden product 90 °, in either direction

to position the garden product in the vertical

edging mode.

Operation

Initial Operation

Switching On

Press the lock-off button 6 and hold while actu-

ating the On/Off switch 5.

Release the lock-off button 6 again.

Switching Off

Release the On/Off switch 5.

Battery Charge-control Indication

The battery charge-control indicator 2 indicates

the charge condition of the battery for a few sec-

onds when the On/Off switch 5 is pressed

through halfway of fully.

Working Advice

f Hold the garden product away from your-

self. Stand in a secure and stable position.

f For more tips on cutting please refer to

website www.bosch-garden.com.

Anti Blocking

The garden product has a patented feature

which works as follows:

If the blade stalls on a tough material, the load

of the motor increases. The intelligent micro-

electronics senses this overload condition and

repeatedly reverses the motor, in order to pre-

vent stalling and to cut the material through.

This audible reversing cut action continues for

up to 3 s.

After cutting through, the garden product con-

tinues in its normal mode, or in case the over-

load condition continues the blades automati-

cally stop in the open position (e. g. in case a

piece of metal fence accidentally blocks the gar-

den product).

n Unplug the handle connector 10.

o To release the garden product from wheel

cart 12, pull the garden product in the direc-

tion shown.

n Loosen the adjustment collar 9.

o Pull the telescopic pipe 8 out to increase the

height, or push it in to decrease the height.

p Re-tighten adjustment collar 9.

LED Capacity

Continuous lighting, green ≥ 35%

Flashing light, green 15 – 35%

Flashing light, red 5 – 15%

Continuous lighting, red ≤ 5%

OBJ_BUCH-904-002.book Page 25 Thursday, August 5, 2010 2:57 PM

1 2 ... 7 8 9 10 11 12 13 14 15

Comments to this Manuals

No comments