Bosch 9000416647(8811) Specifications download pdf (Page 6)

aus

6

Rinse aid

As soon as the rinse-aid refill indicator

4

lights up on the control panel,

refill with rinse aid.

The rinse aid is required for stain-free

utensils and clear glasses.

Use only rinse aid for domestic dish-

washers.

Combined detergents with rinse-aid com-

ponent may be used up to a water hard-

ness of 21 _dH (37 _fH, 26 _Clarke,

3,7 mmol/l) only. If the water hardness

is over 21 _dH, rinse-aid must be used.

Open the dispenser

28

by pressing

and lifting the plate on the cover.

Carefully pour rinse aid up to the max.

mark in the filler opening.

Close cover until it clicks shut.

To prevent excessive foam formation

during the next rinse cycle, remove

any rinse aid which has run over with

a cloth.

Setting amount of rinse-aid

The amount of rinse-aid dispensed can be

set from

to . The factory setting

is

.

Do not change the amount of rinse-aid

unless streaks (select lower setting) or

water stains (select higher setting) are left

on the utensils.

Open the door.

Switch on ON/OFF switch

1

.

Hold down programme button A

and press START button

7

until on

the digital display is indicated

.

Release both buttons.

Press programme button A until the

factory set value

is indicated on

the digital display

8

.

To change the setting,

press programme button C .

Each time the button is pressed, the set

value increases by one level; when the

value of

has been reached, the

display jumps back to (off).

Press START button

7

.

The set value is saved.

Close the door.

Switching off rinse-aid refill

indicator

If the rinse-aid refill indicator

4

is

impaired (e.g. when using combined

detergents containing rinse-aid

component), it can be switched off.

Proceed as described under “Setting

amount of rinse-aid” and set the value

to

.

The rinse-aid refill indicator

4

is now

switched off.

1 2 3 4 5 6 7 8 9 10 11 ... 25 26

Comments to this Manuals

No comments