Bosch SHE7ER55UC Instruction Manual Page 15

  • Download
  • Add to my manuals
  • Print
  • Page
    / 44
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 14
13
Operating the Dishwasher
NOTE: The SHE9ER55UC models have hidden controls, therefore, the door must be opened before chang-
ing settings and closed after changing settings.
Start the dishwasher
1 Press the [On/Off] button. The LED of the last selected cycle flashes.
2 Select a cycle and desired options.
3 Press [Start].
Cancel a cycle
1 Press and hold the [Start] button for approximately 3 seconds until the display reads “0:01”.
2 Wait about 1 minute while the dishwasher drains.
3 Open the door and press the [On/Off] button.
Interrupt a cycle
1 Press the [On/Off] button to turn the unit off.
2 To resume the cycle, press the On/Off button again.
Setting the amount of rinse aid
The amount of rinse aid dispensed can be set from “r:00” to “r:06”.
To change the setting:
1 Press the [On/Off] button.
2 Hold down the “A” button (see page 4) and press [Start] until the display indicates “H:00”.
3 Release both buttons.
4 Press the “A” button until the display shows “r:05”.
5 Press the “C” button to select the desired setting.
r:00” = dispenser is OFF
r:01” = lowest setting
r:02” = low setting
r:03” = medium setting
r:04” = medium/high setting
r:05” = high setting
r:06” = highest setting
6 Press [Start] to save the setting.
Delay Start
You can delay the start of the cycle in one hour increments up to 24 hours.
To set delay start:
1 Press the [On/Off] button.
2 Press the [+] button until the display jumps to “h:01”.
3 Press the [+] or [-] button until the displayed time corresponds with your requirements.
h:01 = 1 hour delay
h:24 = 24 hour delay
4 Press [Start] to activate delay start.
To cancel delay start:
1 Press the [+] or [-] button until “h:00” is indicated on the digital display.
2 Press [Start] to save setting.
Cycle Completion Signal (SHE9ER55UC only)
1 Open the door and press the [On/Off] button.
2 Hold down the “A” button (see page 4) and press [Start] until the display indicates “H:00”.
3 Release both buttons.
4 Press the “A” button until the display shows “b:02”.
5 Press the “C” button to increase or decrease the tone “b:00” = OFF and “b:03” = LOUDEST
6 Press [Start] to save setting and close the door.
Page view 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 43 44

Comments to this Manuals

No comments