Bosch SHEM78W55N Operations Instructions download pdf (Page 30)

en-us Operating the Dishwasher

30

To change the setting:

1.

Press the On/Off button (.

2.

Hold down the function key #

and press the Start button P

until the display 8 indicates

š:‹x (x can be any number).

3.

Release both buttons.

4.

Press the function key # until

the display 8 indicates ˜:‹x.

5.

Press the function key 3 until

the display corresponds with your

requirements.

6.

Press the Start button P.

Switching off the appliance

Short time after the end of the wash

cycle:

1.

Press On/Off button (.

2.

Turn off water supply.

3.

Remove the utensils when they

have cooled down.

9 WARNING

RISK OF INJURY!

To avoid risk of injury, always

use caution when opening the

door during or following a wash

cycle as hot water or steam

may escape. Do not fully open

the door until water noises have

stopped and steam has

subsided.

Interrupting the wash cycle

9 CAUTION

Expansion (overpressure) may

cause the appliance door to

open and/or water to escape! If

the door was opened on an

appliance which has a hot water

connection or is heated, always

leave the door ajar for several

minutes and then close.

1.

Press On/Off button (.

The LED’s go out. The wash cycle

is saved.

2.

To continue the wash cycle, close

the door and press On/Off button

( again.

Note: Your dishwasher is protected

against unintentional operation. If the

appliance door remains open for

more than 4 seconds after pressing

the Start button, the operation will be

paused. Close the appliance door

and press the Start button P again.

Terminating the wash cycle

(Reset)

Terminating the wash cycle

1.

Press and hold Start button P

for approximately 3 seconds until

the display reads ‹:‹‚.

2.

Wait about 1 minute while the

dishwasher drains.

3.

Press On/Off button (.

You may now power the dishwasher

back on and begin a new cycle if

desired.

Changing the wash cycle

When the Start button ( has been

pressed, the wash cycle cannot be

changed. The only way a wash cycle

can be changed is by terminating the

wash cycle (Reset).

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 91 92

Comments to this Manuals

No comments