Bosch SHU 6800 User Manual download pdf (Page 11)

10 - ENGLISH

www.boschappliances.com

HOT WATER CONNECTION

Openings for water lines must be

installed in the marked areas as shown

in Figures 8 and 9 to avoid

interference with the dishwasher

frame or other components.

• If using a solder joint instead of a com-

pression fitting,

be sure to make all

solder connections before connecting

the water line to the dishwasher

.

• Make sure there are no sharp bends or

kinks in the water line which might

restrict water flow.

• When connecting threaded pipe use pipe

thread compound or Teflon tape to seal

the connection.

• Before connecting the copper hot water

supply line to the dishwasher, it should

be flushed with hot water to clear any

foreign material.

• Apply Teflon tape or other pipe sealant

to 90° elbow fitting and connect

directly to water inlet valve*.

• Turn on the water supply to check for

leaks after making connections.

Connecting the Hot Water

Supply Line

Figure 16

Figure 15

Shut off valve

(not included)

THESE INSTALLATION

INSTRUCTIONS ARE

INTENDED FOR USE BY

QUALIFIED INSTALLERS

DO NOT SOLDER WITHIN 6 INCHES

(152.4 MM) OF THE DISHWASHER’S

INLET VALVE.

TEMPERATURES REQUIRED FOR

SOLDERING WILL DAMAGE THE

VALVE!

CAUTION

* Water inlet valve located at the bottom

left front of the dishwasher.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18 19

Comments to this Manuals

No comments