Bosch SPU63M05AU Instruction Manual download pdf (Page 33)

Installation and connection aus

33

Water pressure:

at least 0.05 MPa (0.5 bar), maximum

1 MPa (10 bar). At a higher water

pressure: connect pressure-reducing

valve ahead.

Inlet rate:

minimum 10 litres/minute

Water temperature:

for cold water connection only.

Electrical connection

 Connect the appliance to an

alternating current only, ranging from

220 V to 240 V and 50 Hz or 60 Hz

via a correctly installed socket with

protective earth conductor. See

rating plate for required fusing 9*.

 The socket must be near

the appliance and freely accessible

following installation.

If the plug is not freely accessible, an

allpole disconnector with a contact

opening of at least 3 mm must be

fitted on the installation side

to satisfy the relevant safety

instructions.

 The connection may be modified by

technicians only.

 A power cord extension may be

purchased from customer service

only.

 Use only a residual current operated

circuit-breaker which features

the symbol ‚. Only this extension

guarantees compliance with

the currently valid regulations.

 The appliance features a water

damage protection system. Please

note the system will not function

unless the power supply

is connected.

Removing the appliance

Also observe

the sequence of worksteps here.

1. Disconnect the appliance from

the power supply.

2. Turn off the water supply.

3. Disconnect the waste water

and fresh water connections.

4. Loosen fastening screws for the

furniture parts.

5. If fitted, remove the base panel.

6. Pull out the appliance, carefully

pulling the hose behind.

Transportation

Empty the dishwasher and secure loose

parts.

Drain the appliance according to the

following steps:

1. Turn on the tap.

2. Close the door.

3. Switch on ON/OFF switch (.

4. Select programme with the highest

temperature.

The expected programme duration is

indicated on the numerical display

h.

5. Press START button P.

Programme sequence starts.

6. After approx. 4 minutes press the

START button P until ‹:‹‚ is

indicated on the digital display.

After approx. 1 min ‹:‹‹ is indicated

on the digital display .

7. Switch off ON/OFF switch (.

8. Turn off the tap, disconnect supply

hose and drain water.

Transport appliance upright only.

(This prevents residual water from

running into the machine control and

damaging the programme sequence.)

1 2 ... 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments