Bosch Sensixx x DA50 User Manual download pdf (Page 11)

B O S C H

Trouble shooting

Problem Probable cause Solution

The iron does not

heat up.

1. Temperature control set to

minimum.

2. No mains supply.

3. The “secure” system has

been activated. The iron is

set to stand-by.

1. Turn to a higher position.

2. Check with another appliance

or plug the iron into a different

socket.

3. To reconnect the iron, just move

it about gently.

“Auto off” indicator

lamp ashes.

1. The “secure” system has

been activated. The iron is

set to stand-by.

1. To reconnect the iron, just move

it about gently.

The clothes tend to

stick.

1. The temperature is too high. 1. Turn the temperature control

down and wait until the iron has

cooled down.

Water drips out

of the soleplate

together with steam.

1. Temperature control setting is

too low.

2. Steam control is set too high

in conjunction with a low

temperature.

3. You have pressed the shot

of steam button repeatedly

without waiting for 5 seconds

between each press.

4. Pure distilled water has

been used (see “Filling the

water tank” section) or other

products such as fragrant

water have been added to

the tank.

1. Turn the temperature control to

a higher setting (between “••”

and “max”) and wait until the

indicator lamp goes out.

2. Set the steam control to a lower

setting.

3. Wait 5 seconds between each

press of the jet of steam button.

4. Mix distilled water with tap

water as directed in the “Filling

the water tank” section and

never add any other products

to the water tank (unless

recommended by Bosch).

Steam does not

come out.

1. Steam control is set to

position.

2. No water in the tank.

3. The temperature is too low.

Anti-drip system is activated.

1. Set the steam control to a

higher position.

2. Fill the tank.

3. Set to a higher temperature if

compatible with the fabric.

Spray does not

work.

1. No water in the tank.

2. Obstructed mechanism.

1. Fill the water tank.

2. Contact the Technical Service.

Smoke comes out

when connecting the

iron for the rst time.

1. This may be caused by the

lubrication of some of the

internal parts.

1. This is normal and will stop

after a few minutes.

Deposits come out

through the holes in

the soleplate

1. Traces of lime scale are

coming out of the steam

chamber.

1. Carry out a cleaning cycle (see

“Calc’n clean” section).

If none of the above solves the problem, get in touch with an authorised technical service.

You can download this manual from the local homepages of Bosch.

1 2 ... 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Bosch Sensixx x DA50 User Manual Page 11

Comments to this Manuals

Related products and manuals for Irons Bosch Sensixx x DA50