Bosch IntuiKey User Manual download pdf (Page 21)

IntuiKey Keyboard Controlling Allegiant Series Video Switchers | en 17

Bosch Security System, Inc. User Manual F.01U.127.291 | 1.93 | 2009.03

2.4 Allegiant Error Messages

Error Name Description

Error 01 Invalid Camera Request The camera number entered from the keyboard does not exist. If

using the optional LTC 8059/00 Master Control Software or the LTC

8850/00 Graphical User Interface Software, ensure that the number

exists in the Camera Identification table. Download the table to be

sure.

Error 02 Invalid Monitor Request The monitor number entered from the keyboard does not exist.

Error 03 Remote Device Locked by User# The remote device requested cannot be controlled, because it is

locked by a user with equal or higher priority. Check with the other

users or request that a higher priority user unlock the remote

device.

Error 04 Monitor Locked by User# The monitor requested cannot be accessed, because it is locked by

a user with equal or higher priority. Check with the other users or

request that a higher priority user unlock the monitor.

Error 05 Remote Device Access Restricted Remote locked out by Remote Lock Out table.

Error 06 Monitor Access Restricted Monitor locked out by Monitor Lock Out table.

Error 10 Access Denied A function was requested for which the user priority is too low. Only

a Priority 2 user or a supervisor with Priority 1 may access this

function.

Error 11 Access Denied A function was requested for which the user priority is too low. Only

a supervisor with Priority 1 may access this function.

Error 15 Invalid User Function The function number requested from the keyboard is invalid. Refer

to the User Function table for a listing of valid user function

numbers.

Error 20 Acknowledge Denied The ACKNOWLEDGE button was pressed by a user without the

authority to acknowledge alarms.

Error 21 Incorrect Acknowledge In order to properly acknowledge an alarm event, the keyboard

must be switched to a monitor that is displaying the alarms.

Error 22 Acknowledge Disabled Alarms on this monitor cannot be acknowledged, because that

capability has been disabled by the system programmer.

Error 23 Camera not in Alarm The camera displayed on the monitor is not an alarm video; only

alarm-generated video can be acknowledged.

Error 24 Keyboard Not Enabled for

Acknowledge

This keyboard may not acknowledge alarm video on this monitor; it

has been disabled by the system programmer.

Error 25 Alarm Switcher Running Alarm video may only be acknowledged if the alarm switcher is not

running; press HOLD to stop the switcher.

Error 50 Sequence Not Available The user attempted to load a switcher sequence that does not exist.

This is a good way to determine, from the keyboard, which

sequence numbers are unused when desiring to add one. A request

was made to load an ABSOLUTE type sequence, without the

keyboard being on one of the monitors in that sequence. Because

inadvertent loading of monitors should be avoided, the user is

required to switch his keyboard to one of the monitors used by the

sequence. The PROGRAM mode may be used to review which

monitors are used in the sequence.

Error 52 Sequence Request A request was made to load a RELATIVE type sequence on a monitor

number that is too high; the monitors used by the sequence would

extend past the highest monitor. Try switching to a lower monitor

number before loading the sequence.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 49 50

Comments to this Manuals

No comments

Bosch IntuiKey User Manual Page 21

Comments to this Manuals

Related products and manuals for Keyboards Bosch IntuiKey