Bosch BER634GS1 Instruction Manual download pdf (Page 19)

Trouble shooting en

3 Trouble shooting

Trouble shooting

If a fault occurs, there is often a simple explanation.

Before calling the after-sales service, please refer to the

fault table and attempt to correct the fault yourself.

Tip: If a dish does not turn out exactly as you wanted,

refer to the following chapter, where you will find lots of

tips and notes relating to the optimum

settings.~ "Tested for you in our cooking studio"

on page 21

:Warning

Risk of electric shock!

Incorrect repairs are dangerous. Repairs may only be

carried out and damaged power cables replaced by

one of our trained after-sales technicians. If the

appliance is defective, unplug the appliance from the

mains or switch off the circuit breaker in the fuse box.

Contact the after-sales service.

Fault table

--------

Fault Possible cause Remedy/information

The appliance does not work or the

display is not working

The plug is not plugged into the mains Connect the appliance to the electricity supply

Power cut Check whether other kitchen appliances are working

The circuit breaker is faulty Check in the fuse box to make sure that the fuse for

the appliance is OK

Faulty operation Switch off the circuit-breaker for the appliance in the

fuse box and switch it back on after approx. 60 sec-

onds

The appliance cannot be started The appliance door is not fully closed Close the appliance door

Appliance does not heat up.

Them symbol for demo mode is

shown in the display.

The appliance is in demo mode Deactivate demo mode in the basic settings.

To do this, briefly disconnect the appliance from the

mains (switch off the household fuse or the circuit

breaker in the fuse box). Then deactivate demo mode

in the basic settings within 3 minutes.

The rotary selector has fallen out of

the support in the control panel.

The rotary selector has been accidentally disengaged. The rotary selector can be removed. Simply place the

rotary selector back in its support in the control panel

and push it in so that it engages and can be turned as

usual.

The rotary selector can no longer be

turned easily.

There is dirt under the rotary selector. The rotary selector can be removed. To disengage the

rotary selector, simply remove it from the support.

Alternatively, press on the outer edge of the rotary

selector so that it tips and can be picked up easily.

Carefully clean the rotary selector and its support on

the appliance using a cloth and soapy water. Dry with

a soft cloth. Do not use any sharp or abrasive materi-

als. Do not soak or clean in the dishwasher.

Do not remove the rotary selector too often so that the

support remains stable.

The interior lighting is not working The interior lighting is faulty Call the after-sales service

Error message "Exxx"* If an error message is displayed, switch the appliance

off and on again; if the message disappears, it was a

one-off problem. If the fault occurs again or the error

message is still displayed, please contact the after-

sales service and provide the fault code.

* Special features:

Error message "E0532": Open and close the appliance door.

Error message "E6501": Switch off the appliance. Wait for 10 minutes. Switch the appliance on again.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 51 52

Comments to this Manuals

No comments

Bosch BER634GS1 Instruction Manual Page 19

Comments to this Manuals

Related products and manuals for Kitchen & houseware accessories Bosch BER634GS1