Bosch RPS D5500CU Installation Guide download pdf (Page 9)

System overview

With Remote Security Certificate Builder, you collect specific remote programming software

data (for example, the RPS passcode), and create a secure certificate that allows an RSC user

to log on to the control panel shown in the certificate. Each certificate allows a single user to

connect to a single control panel. The RSC app is available for Android and Apple iOS devices.

1 3 52

4 6

ZONEX COMMON

EARTH

GROUND

COMMON

BATTERY NEGATIVE ONLY

BATTERY POSITIVE ONLY.

RELAY A

RELAY B

RELAY C

+ AUX POWER

CLASS 2 TRANSFORMER

16.5 VAC 40 VA 60 Hz

Model D1640

Internally Fused - Do not short

Requires Unswitched Outlet

Do not share with other equipment

S4 GROUND FAULT DETECT

Enabled

Disabled

RED

ON when communicating

OFF when idle

Commercial Protected-Premises Control Panel

System is intended to be checked by a Qualified Technician at least every 3 years.

The types of initiating circuits the control panel has been approved for are A, M, W, SS.

The types of signaling the control panel has been approved for are DAC, OT, NC, RevPol.

VOLTAGE RANGES

Open 3.7 - 5.0 VDC Short 0.0 - 1.3 VDC

Normal 2.0 - 3.0 VDC

SDI

RED

POWER +

YELLOW

DATA BUS A

GREEN

DATA BUS B

BLACK

COMMON

ZONEX OUT 1

ZONEX IN 1

NFPA

Style 4.0

Signaling

Line

Circuits

F01U201283-03

LEDs Off when Normal

YELLOW - Charging Status

RED - Low Battery - 12.1 VDC

10.2 VDC - Battery Load Shed

This equipment should be installed in accordance with the NFPA 70 (National Electrical Code) and

NFPA 72 (National Fire Alarm Code).

D9412GV4

ZONEX POWER +

PHONE LINE SEIZED LED

TIP

RING

TELCO CORD MODEL D161

POWER SUPPLY REQUIREMENTS

The Power Supply provides a maximum of 1.4 Amps for the Control Panel and all

Accessory Devices. For System Loading, refer to the GV4 Series Control Panel

Operation and Installation Guide (P/N: F01U201527).

Guide (P/N: F01U201527) for Power Requirements relating to Terminals 6 and 7 .

CAUTION:

Refer to the GV4 Series Control Panel Operation and Installation

All external connections except Terminal 5 (battery positive) are inherently power

limited. Requirements for battery standby time might reduce allowable output.

WARNING!

Multi-Battery installation requires

Model D122 or D122L Dual Battery

Harness. Improper installation can

be a fire hazard.

Battery: Replace every 3 to

5 years with one or two Model

D126 or D1218 12 V Lead Acid

Batteries.

PROGRAMMABLE

ALARM OUTPUTS

Terminals

SWITCHED AUX

and

Terminal

Operation

Monitor

LED

Pulses when

Normal

Flickers when

Ringing

GREEN

Point 3

Point 4

1614 15

Point 1

Point 2

1211 13

Point 5

Point 6

Point 7

Point 8

Incorrect wiring will

damage this equipment.

Suitable for dry indoor

use only.

Devices powered by any

power output must

be supervised.

Minimum system requirements for Classification in accordance with ANSI/SIA CP-01-2010

UL Listed and Classified control unit Model D9412GV4, D7412GV4, or D7212GV4;

UL Listed and Classified keypad Model D1256, D1257, D1260, D1255, D1255R, or D1255RB;

UL Listed Local Bell

WARNING!

To prevent risk of

electric shock,

disconnect AC

power and

telephone lines

before servicing.

CAUTION:

Avoid damage to Panel.

Do not connect 24 V to terminals.

Maximum charging current 1.4 A

ZONEX OUT 2

ZONEX IN 2

Not suitable for remote station protected premises services where separate transmission circuits

are required for fire, supervisory (when applicable) and trouble signals when using D185.

The D9412GV4 Control Panel is UL Listed For Central Station, Remote Station, Local, Auxiliary,

Proprietary, and Household Fire Alarm, and Central Station, Local, Proprietary,

Police Station Connect, Household Burglar Alarm

and Encrypted Line Security when

communicating via a network.

SDI2

RED

POWER +

YELLOW

DATA BUS A

GREEN

DATA BUS B

BLACK

COMMON

Refer to the GV4 Series Control Panels Approved Applications Compliance

Guide (P/N: F01U201525) for System Wiring Diagram, Issue A and for

compatible smoke detectors. 2-wire Compatible Identifier “A”.

SDI Connector

SDI2 Connector

Remote

programming

software

database

Remote Security

Certificate

Builder

Certificate

Figure 2.1: System overview

Callout ￚ Description

1 ᅳ Credentials and account data within remote programming software

2 ᅳ Encryption, validity data, dealer information, and output and door limitations pulled into

Remote Security Certificate Builder

3 ᅳ Email the certificate generated on the Remote Security Certificate Builder computer to

the compatible device

4 ᅳ Compatible device with Remote Security Control installed

5 ᅳ Certificate and account details, status information, and commands communicated

between Remote Security Control and a compatible control panel using Ethernet or cellular

communications.

6 ᅳ Compatible control panel (D9412GV4 shown)

Remote Security Certificate Builder creates certificates from and for use with the following:

Compatible control panels

Remote Security Certificate Builder can create certificates for the following control panels:

– B9512G/B8512G, B9512G-E/B8512G-E (“E” variants require an Ethernet or cellular

module)

– B5512/B4512/B3512, B5512E/B4512E/B3512E (“E” variants require an Ethernet or

cellular module)

– D9412GV4/D7412GV4/D7212GV4

– Solution 2000/3000 (ICP-SOL2-P/ICP-SOL3-P) (requires an Ethernet module)

Compatible remote programming software

Remote Security Certificate Builder uses the remote programming software database to create

certificates:

– Remote Programming Software v5.15.4 and higher

– A-Link Plus Remote programming Software v4.5 and higher

Note that your control panel and the latest Remote Security Control features might require the

latest version of remote programming software.

Compatible devices for certificates

RSC and Remote Security Certificate Builder support both Android and iOS devices:

– Android devices with Android version 4.0.3 (Ice Cream Sandwich) and higher

– iPhone, iPod Touch, iPad with Apple iOS 6.0 and higher

Remote Security Certificate Builder System overview | en 9

Bosch Security Systems, Inc. Installation Guide 2015.04 | 06 | F01U262845

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Bosch RPS D5500CU Installation Guide Page 9

Comments to this Manuals

Related products and manuals for Laptops Bosch RPS D5500CU