Bosch D9210B User Manual download pdf

Update Kit D9210B

Installation Instructions

Internal testing has found that if a D9210B (version 1.08 firmware) is currently in the energized state and a Reset is

performed on the panel (manual reset using the reset switch or a Reset-Bye using RAM3), the D9210B may deenergize

the Lock Relay after a 30-minute delay. Version 1.12 corrects this issue. The following instructions indicate how to

replace the existing firmware chip with the new version.

1.0 Introduction

This Update Kit has been provided to allow existing D9210B Access Interface Modules (v. 1.08) to be updated with the

latest firmware revision. This is accomplished by replacing the EPROM chip in the unit with the microchip included in

the Update Kit.

Note: This update kit is not compatible with the D9210B version 1.06 or lower.

2.0 Requirements

You will need a PLCC extraction tool for this procedure. This tool is not supplied with the

update kit but may be purchased at Radio Shack (Part Number: 276-2101) or other electronic

stores.

Do NOT use a screwdriver or any other prying device for this procedure.

Incorrectly removing or replacing the chip may damage the board. Bosch Security

Systems cannot be responsible for products damaged as a result of incorrectly

removing and installing the chips.

3.0 Updating the D9210B

3.1 Before you begin

Power down the module by disconnecting Aux power (Terminal 1) and SDI A and B (Terminals 6 and 7).

3.2 Locating the chip to be removed

The chip to be replaced is resting in a square socket in the upper right corner of the board. See the diagram below.

D9210B

REV-1.08

EPROMToBeRemoved

1 2

Update Kit D9210BInstallation InstructionsInternal testing has found that if a D9210B (version 1.08 firmware) is currently in the energized state and

Bosch D9210B User Manual