Bosch D7212G Installation Guide download pdf (Page 44)

D7212G Operation and Installation Guide

D7212G

Off-board Points

8.4.6 OctoPOPIT Sensor Loops

Only the resistance on the loop limits the number of normally-open and/or normally-closed detection devices each sensor

loop can supervise. Resistance on each sensor loop must be less than 100 Ω with the detection devices connected.

Certain UL and NFPA applications may limit the number of detection devices. Consult the appropriate UL or NFPA

standards.

The OctoPOPIT detects open, short, normal, and grounded circuit conditions on its sensor loops and transmits the

conditions to the panel. Each sensor loop is assigned a point number and transmits to the panel separately.

Bosch Security Systems recommends you use twisted-pair wire for the OctoPOPIT sensor loops to avoid EMI problems.

Run wires away from the premises telephone and AC wiring. If you suspect a noisy environment, use shielded cable.

There are two rows of terminal numbers on the OctoPOPIT. In the row closest to the terminal blocks, the positive outputs

for the sensor loops are labeled P1 to P8. Sensor loop outputs P1 and P2, P3 and P4, P5 and P6, and P7 and P8 share

common terminals. The common terminals for each pair are labeled COM.

Terminate each OctoPOPIT sensor loop with a 1 kΩ end-of-line resistor. Attach a resistor even if you don’t enable the loop.

The OctoPOPIT comes with a D105BL resistor for each sensor loop.

Take care not to duplicate point assignments. Points assigned to both an OctoPOPIT sensor loop and a POPIT, two

OctoPOPIT sensor loops, or two POPITs do not function properly.

8.4.7 Address Assignment Switches

Switches 1, 2, 3, and 4 assign the OctoPOPIT sensor loops to point numbers on the panel. Table 10 shows the OctoPOPIT

switch settings for point assignments.

ZONEX 1 D8128D Address Switches

Points 9-127 1 2 3 4 5

9-16 ON ON ON ON *

17-24 ON ON ON OFF *

25-32 ON ON OFF ON *

33-40 ON ON OFF OFF *

*Line Termination Switch (see section 8.4.5 Line Termination,

page 45 for line termination switch settings).

Table 10: D8128D OctoPOPIT Switch Settings for D7212G

8.5 Testing Off-board Points

Use the Service Walk Test to test off-board points. See the D9412G/D7412G/D7212G Installation and Troubleshooting Quick

Reference Guide (P/N: 43700) for instructions. Test to be sure that all off-board points operate properly.

Walk test does not show extra points: If the point assignment switches on a POPIT or OctoPOPIT are set incorrectly, it may

create both missing and extra point conditions. If the same point number is assigned to two or more POPITs or

OctoPOPITs, none of the points with that number will test correctly. Refer to Section 8.1 Point (ZONEX) Bus D7212G

Terminals 27 to 28 on page 37 for additional infomation on how to troubleshoot POPITs or extra point conditions.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 67 68

No comments

Bosch D7212G Installation Guide Page 44