Bosch CCS 900 Ultro Service Manual download pdf (Page 30)

30 en | Built-in MP3 recorder (CCS-CURD only) CCS 900 Ultro

IOM_CCS900 | V1.0 | 2010.06 Installation and Operating Manual Bosch Security Systems B.V.

7.4 Record

Use the record mode to record discussion. Before recording, make sure the SD card is

inserted into the slot to the right of the display, or the unit is set to internal recording.

7.4.1 Overview of record icons

The following icons are displayed/used during recording.

Table 7.3 Overview of record icons

Icon Icon name Function of icon

Record selected Shows the user that the Record mode is selected.

Record Starts recording session.

Pause Pauses recording session. When recording has been paused,

the record icon will appear and start to flash. Press the

record button to reactivate recording.

Stop Stops recording session

New file Creates a new file during recording (recording continues,

but the data is saved under a new file name. The time

counter on the display is also reset).

Change card Allows the user to change the SD card during recording (see

section 7.4.3).

Change card timer Graphically shows the user how many seconds are

remaining before the new card must be inserted.

Hourglass Icon will flash at 2Hz when the SD card is being initialized.

During the initialization all control buttons are disabled.

SD card status Card flashing at 2 Hz: card is missing.Card flashing at 5 Hz:

card is either full, write protected, or incompatible.Note:

This icon is not shown during the card exchange procedure

or when the internal memory option is selected in the set-up

mode.If during the card exchange procedure a card is not

inserted within one minute of pressing the change card

button, this icon will appear.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 45 46

No comments

Bosch CCS 900 Ultro Service Manual Page 30