Bosch HDC200 Use and Care Manual download pdf (Page 5)

-5-

Maintenance

Service

Preventive maintenance

performed by unauth-

orized per so n nel may result in misplacing

of internal wires and components which

could cause serious hazard. We

recommend that all tool service be performed

by a Bosch Factory Service Center or Autho -

rized Bosch Service Station.

Cleaning

To avoid accidents always

dis connect the tool from

the power supply before cleaning or

performing any main tenance. The tool may

be cleaned most effectively with compressed

dry air. Always wear safety gog gles when

cleaning tools with compressed air.

Ventilation openings and switch levers must

be kept clean and free of foreign matter. Do

not at tempt to clean by inserting pointed

objects through openings.

Certain cleaning agents

and sol vents damage

plastic parts. Some of these are: gasoline,

carbon tetrachlo ride, chlo rinated cleaning

solvents, ammonia and house hold

detergents that contain ammonia.

!

WARNING

!

WARNING

!

CAUTION

Tool Tips

DRILLING WOOD OR PLASTIC

Do not drill into wood with dust extraction

system mounted. Wood chips are typically too

large and will clog the dust channel.

If backing block is not used,

ease up on the pressure just

before the bit breaks through the wood to

avoid splintering. Complete the hole from the

opposite side immediately after the point

breaks through. If bit binds, reverse the

drilling operation to help remove the bit from

the work.

DRILLING METAL

Do not drill into metal with

the dust extraction system

mounted. Hot metal chips can self-ignite or

ignite parts of the dust extraction system.

!

CAUTION

!

WARNING

161992A07A-HDC200 HDC250_HDC200 HDC250 1/10/14 1:05 PM Page 5

1 2 3 4 5 6 7 8 9 10 ... 15 16

Comments to this Manuals

No comments