Bosch Maxx 2,5 Operations Instructions download pdf (Page 58)

Connecting the water m Risk of electric shock!

To prevent leaks or water damage, it is essential to fol-

low the instructions in this chapter!

Water inlet hose Caution

Operate the washer-dryer with cold drinking water only.

Do not connect to the mixer tap of an unpressurised

hot-water apparatus.

If in doubt, have the appliance connected by a special-

ist.

Do not use a used inlet hose. Only use the inlet hose

supplied or one which was purchased from an autho-

rised specialist dealer.

The water inlet hose must not be

– kinked or crushed,

– modified or severed (strength is no longer guaran-

teed).

Plastic threads must only be tightened by hand. Do not

remove the strainers from the water supply hose.

Check the mains water pressure:

– The water pressure should be between 1 and 10

bars (when the tap is turned on, at least 8 litres of

water is discharged per minute).

– If the water pressure is higher, install a pressure

reducing valve.

Connect the water supply hose

■ to the rear panel of the washer-dryer and ...

■ to the tap.

■ After connecting the water inlet hose: Turn on the

water tap completely, and check connection points

for water-tightness.

■

min. 10 mm

Downloaded From WashingMachine-Manual.com Manuals

1 2 ... 53 54 55 56 57 58 59 60 61 62

No comments

Bosch Maxx 2,5 Operations Instructions Page 58