Bosch WFK 2401 Instruction Manual download pdf (Page 14)

IX.

X

XI.

Xll.

Turn off washer by depressing the "ON/OFF"

button.

Open the door, remove the wash load and

leave the door slightly open to allow the

inside of the washer to dry after each use.

Remove any foreign objects from the drum

seal that may have come to rest there during

running of the washer. Otherwise there is

risk of sharp object or other item that may

rust being left on the seal and damaging it.

Close the water valve(s). If you have

completed washing for the day close the

water valve(s)

DELAYED START:

The start of the washing cycle can be delayed up

to 19 hours, in b-hour increments. Perform the

same steps I through V as described above under

the heading "IMMEDIATE START", but instead of

depressing the "START" button proceed as

follows:

On/Off

e

!

Figure 15.

XIII. Press "DELAY START HOURS" button, see

figure 15. The alphanumeric display above

the button will display "lh" indicating that a

one hour delay has been selected. Press the

"DELAY START HOURS" button as many

times as necessary, or hold it in, to display

the number of hours delay desired,

A small dot will flash on and off, in lower dght

hand comer of display, to indicate the washer is

counting down from the set time. The washer

will count down in one-hour increments and will

start once the indicated delay has past.

Notes: 1. The delay time may be altered or cancelled

at anytime, before the washer starts, by

depressing the "DELAY START HOURS"

button and holding it in. Then either hold it

in until the new desired delay time appears

or, until the display passes "19". If held in

past the "19" being displayed the start time

is cancelled and will display the cycle

duration time as soon as the button is

released. Press the "DELAY START

HOURS" button again to begin the delay

setting again in one hour increments.

2. The door may be opened after the delayed

start time has been set to add more wash

until the washer starts.

3. To start the washer immediately even

though the delay start has been set simply

press the =Start" button.

When the cycle ends the steps for DELAYED

START are again the same as for IMMEDIATE

START. See steps VII through Xll, above.

14

1 2 ... 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments