Bosch WVH30542EU Installation Manual download pdf (Page 19)

Operating the appliance en

19

End of the programme

– 0 – and – – – is indicated in the

display and acoustic signal sounds.

Setting the signal ~ Page 27

If – – – (Rinse stop = without final drain/

spin cycle) was selected, touch the

Start/Reload A button to start the final

drain/spin cycle.

Notes

■ The programme continues by

pumping out the water and spinning

the laundry (the standard spin speed

can be changed beforehand).

■ If only the water is to be pumped out,

approx. 1 minute after the

programme starts, touch the Start/

Reload A button before the spin

cycle starts, then turn the

programme selector to Ú Off. The

programme is interrupted and the

door lock is released. The laundry

can be removed.

■ If the drying function is actuated,

PUSH, to, End alternates on the

display, the Start/Reload A

indicator light flashes and an

acoustic signal sounds:

■ Drum continues running for 30 min

in special pace to prevent laundry

from creasing.

■ If you want to remove the laundry

immediately, touch any button to

cancel or reselect a programme.

■ If hot flashes in the display before

the drying programme ends, the

temperature in the drum is high. The

programme for cooling the drum

runs until the temperature in the

drum has dropped.

After washing/drying

1. Open the door and remove the

laundry.

2. Turn the programme selector to

Ú Off. The appliance is switched off.

3. Turn off the tap.

Not required for Aqua-Stop models.

~ Page 37

Notes

■ Do not leave any items of laundry in

the drum. In the next wash they may

shrink or discolour another item.

■ Remove any foreign objects from

the drum and the rubber seal - risk

of rust.

■ Leave the detergent drawer and

door open so that residual water can

evaporate.

■ Always remove the laundry.

■ Always wait until the programme

ends, as the appliance could still be

locked. Then switch the appliance

on and wait for the unlocking device.

■ When the display panel has gone

out at the end of the programme,

energy-saving mode is active. To

activate, select any button.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 43 44

Comments to this Manuals

No comments