10
Introduction to DSC
Control Module/ Hydraulic Unit
The control module used on the DSC III sys-
tems varies between models. The DSC III
5.3 system uses the same control module
configuration at the ASC+T5 system.
The control module is an 83 pin unit located
in the E-box.
The DSC III 5.7 system integrates the control
module into the hydraulic unit. This reduces
the size and wiring required for DSC opera-
tion. Additionally the motor relay and valve
relay have been replaced by solid state final
stages in the control module.
On E39 and E39 applications, the control module/hydraulic unit is located ahead of the
passenger side strut tower. The hydraulic unit contains the following components:
• Two pre-charge solenoid valves
• Two changeover solenoid valves
• Four intake solenoid valves
• Four outlet solenoid valves
• One return pump
83 Pin Control Module Bosch DSC III 5.3
Control Module/Hydraulic Unit Bosch DSC III 5.7
Comments to this Manuals