Bosch LTC 5141 Series Instruction Manual download pdf (Page 8)

Bosch Security Systems | 13 February 2004

5OPERATION

5.1 RUN Button and Indicator

Momentary depression of the RUN button initiates

automatic sequencing known as the run mode. The

Green LED above this button will indicate the switcher

is in the run mode.

5.2 DWELL Control

This control is located on the rear panel. This

adjustment controls the rate at which the cameras are

sequenced during the run mode. Rotating the control

clockwise slows the rate of sequencing (increases the

dwell time). Rotating the control counter-clockwise

causes the switcher to sequence faster (decreases the

dwell time). The dwell time is approximately 2 seconds

when the control is turned fully counter-clockwise; full

clockwise rotation of the control provides a dwell time

of approximately 45 seconds.

5.3 Camera Buttons and Indicators

These buttons are used to call-up a camera and stop

automatic sequencing. When a camera button is

pressed, that camera will be called-up to the monitor

screen, the camera LED indicator will light, and the

RUN LED indicator will go out.

LTC 5121, LTC 5141 | Instruction Manual | Operation

Figure 1 Front and Back Panels

6ILLUSTRATIONS

6.1 LTC 5121/60, LTC 5121/50

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Bosch LTC 5141 Series Instruction Manual Page 8